[cisco-voip] MAC address for SCCP controlled VIC3-2FXS-E/DID card

[Dschulz]

The loopback can be used and is preferable to use it. However, you need to make sure it is included in your routing table.

Dave


-----Original Message-----
From: Peter Slow <peter.slow at gmail.com>
Sent: Sunday, April 25, 2010 5:32 PM
To: Bill <bill at hitechconnection.net>
Cc: cisco-voip voyp list <cisco-voip at puck.nether.net>
Subject: Re: [cisco-voip] MAC address for SCCP controlled VIC3-2FXS-E/DID	card

Since when can't you use a loopback interface is your SCCP bind
interface? I'm not aware of that limitation.

-Peter

On Fri, Apr 23, 2010 at 11:34 AM, Bill <bill at hitechconnection.net> wrote:
> I don’t think you can use a loopback for this. If I remember right this is
> the same as setting up a transcoder / conference bridge resource and you
> have to use a physical adaptor.
>
>
>
> ________________________________
>
> From: Lelio Fulgenzi [mailto:lelio at uoguelph.ca]
> Sent: Friday, April 23, 2010 10:30 AM
> To: Bill
> Cc: cisco-voip voyp list
> Subject: Re: [cisco-voip] MAC address for SCCP controlled VIC3-2FXS-E/DID
> card
>
>
>
> hmmm, i'm going to be using a loopback address.
>


[The entire original message is not included]