[cisco-voip] configuring a gateway

[Nick Matthews]

It's dated but it works with MGCP:
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00807f8b70.shtml

On Fri, Apr 30, 2010 at 9:46 AM, Robin Clayton
<Robin.Clayton at rrca.org.uk> wrote:
> Hi
>
> I am trying to get back into setting up my home test lab. Currently I have a
> 1760 and a 2621, one has a PSTN connection and CME4 with two cisco phones,
> the other has 2 analouge phones. I even have E&M between the two as a
> failover... This all works as expected.
>
> What I have never got working is using the 1760 as a gateway router
> for CUCM6 virtualised on VMWARE. I have tried a basic gateway setup in CUCM
> with the route pattern set to phones on the gateway router. and vice versa
> phone on the router with dial peers set to cucm.
>
> BUt calls never complete, they wait and then get the fast busy tone.
>
> I am sure I am probably doing something silly but can't work it out. IT's
> been a few months since I last tried..
>
>
> Has anyone got a rough and ready guide to gateway configuration between
> CUCM6 and a Router running IPVoice?  I have scoured the internet many times
> but never found a simple guide.
>
> Cheers
>
> Rob
>
>
> ===============================
> Robin Clayton
> Network Manager
> Tel: 01228822075
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>