[cisco-voip] FW: PRI Issues
Monica Hardy
Monica.Hardy at openwave.com
Tue Aug 3 16:08:22 EDT 2010
running System version: 7.0.2.22030-1
From: Monica Hardy
Sent: Tuesday, August 03, 2010 12:54 PM
To: cisco-voip at puck.nether.net
Subject: PRI Issues
Hello everyone,
I am hoping someone could shed some light.
I have 2 PRI's on one MGCP GW and 2 more on another MCCP GW. I have set them up identical.
All 4 PRI's are part of the same RG.
We have a toll free number from a provider that forwards to a number in our DID range. After the call comes in it is then forwarded to an international number.
888 Incoming number à forwarded to extension in our DID rangeà this extension is CF to a international number
On one of the gateways if I set the 'Calling Party Selection ' to 'Last Redirect Number(external) the call goes through. If I leave it set on 'Originate' the call fails and this is what I see in the debug:
Aug 3 16:40:39.553: ISDN Se0/0/1:23 Q931: TX -> CONNECT_ACK pd = 8 callref = 0x000E
Aug 3 16:40:56.937: ISDN Se0/0/0:23 Q931: TX -> SETUP pd = 8 callref = 0x0010
Bearer Capability i = 0x8090A2
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98396
Exclusive, Channel 22
Calling Party Number i = 0x2183, '91650743XXXX'
Plan:ISDN, Type:National
Called Party Number i = 0x80, '01144208814XXXX'
Plan:Unknown, Type:Unknown
Aug 3 16:40:57.057: ISDN Se0/0/0:23 Q931: RX <- CALL_PROC pd = 8 callref = 0x8010
Channel ID i = 0xA98396
Exclusive, Channel 22
a 91 is added to the Calling Party Number, so the call fails. It only does this on one of the Gateways. On the other the 'Originator' setting works fine.
I can't figure out where this 91 is coming from and why it would only come on one gateway and not the other.
Any ideas?
-Monica
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100803/9e814a2f/attachment.html>
More information about the cisco-voip
mailing list