[cisco-voip] 6500 720 Config for ws-svc-cmm

[Jason Aarons (US)]

If you look at the release notes for that Sup 720 IOS with VSS did you verify the WS-SVC-CMM module is supported?

Once you insert the module double check  under show module it's happy if supported.

From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of george.hendrix at l-3com.com
Sent: Wednesday, August 11, 2010 9:30 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] 6500 720 Config for ws-svc-cmm

Hi everyone,

  I am migrating from a pair of 6500 switches to a new pair of 6509-E with VS-720 Sup engines.  We currently have a ws-svc-cmm modules installed and I am trying to determine if there is any "special" command I need to assign the module's gig interface to the correct vlan.  For instance, the NAM module is configured quite a bit different with Sup 720s than with the Sup 2 engine.  With the ws-svc-cmm, is the entry below only thing I need to configure on the new 6500-E?  Of course, I won't be able to configure it until the module is installed.

i.e.

Interface GigabitEthernet 8/1
Switchport
Switchport access vlan 100


Thanks,

Bill Hendrix




-----------------------------------------
Disclaimer: 

This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only.  If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful.  If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100811/5bcf83e5/attachment.html>