[cisco-voip] Upgrade from 2801 to 2911
Guilherme Loch Waltrick Góes
glwgoes at gmail.com
Thu Aug 12 10:25:15 EDT 2010
We upgraded to 15.0M3 and that seems to fiexed the issue.
Thanks for your help.
Guilherme Loch Góes
On Mon, Aug 9, 2010 at 1:13 PM, Ted Nugent <tednugent73 at gmail.com> wrote:
> Your PBX is emulating ISDN network but your router is providing clock? I
> would double check that. Typically and logically both functions are
> performed by the same device, its not required but it makes sense.
> Also as mentioned above....
> network-clock-select 1 E1 0/1/0
>
>
> On Mon, Aug 9, 2010 at 10:37 AM, Guilherme Loch Waltrick Góes
> <glwgoes at gmail.com> wrote:
>>
>> It's a simple voice gateway, there is no CCM.
>>
>> I'll try to upgrade to 15.0M3 and will report the status.
>>
>> Thanks for your help.
>>
>> Regards,
>>
>> Guilherme Loch Góes
>>
>>
>>
>>
>> On Mon, Aug 9, 2010 at 11:11 AM, Burak Dag <burdag at gmail.com> wrote:
>> > Hi,
>> >
>> > can you check the region on ccm and the codecs??
>> >
>> > Thanks
>> >
>> >
>> > 2010/8/9 Guilherme Loch Waltrick Góes <glwgoes at gmail.com>
>> >>
>> >> Hi guys,
>> >>
>> >> We just upgraded a site that was running a 2801 with a ISDN PRI link
>> >> to a PBX to a 2911 with the exact same setup. The setup with the 2801
>> >> was running just fine. The problem is, running with the same config on
>> >> the 2911 we keep getting MANY Line Code Violations and other assorted
>> >> errors, the calls are very noisy and sometimes we can't place the
>> >> calls from this site to the other sites.
>> >>
>> >> Did anyone experienced the same situation? How can a solve this
>> >> problem?
>> >>
>> >> Bellow is some info about this router:
>> >>
>> >> #sh controllers e1 0/1/0
>> >> E1 0/1/0 is up.
>> >> Applique type is Channelized E1 - balanced
>> >> Description: Enlace E1 com o PABX
>> >> No alarms detected.
>> >> alarm-trigger is not set
>> >> Version info Firmware: 20090408, FPGA: 13, spm_count = 0
>> >> Framing is NO-CRC4, Line Code is HDB3, Clock Source is Internal.
>> >> Data in current interval (38 seconds elapsed):
>> >> 20724 Line Code Violations, 170 Path Code Violations
>> >> 1 Slip Secs, 0 Fr Loss Secs, 38 Line Err Secs, 0 Degraded Mins
>> >> 38 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail
>> >> Secs
>> >> Data in Interval 1:
>> >> 415943 Line Code Violations, 4586 Path Code Violations
>> >> 6 Slip Secs, 0 Fr Loss Secs, 900 Line Err Secs, 15 Degraded Mins
>> >> 900 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail
>> >> Secs
>> >> Total Data (last 1 15 minute intervals):
>> >> 415943 Line Code Violations, 4586 Path Code Violations,
>> >> 6 Slip Secs, 0 Fr Loss Secs, 900 Line Err Secs, 15 Degraded Mins,
>> >> 900 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail
>> >> Secs
>> >>
>> >> #sh ver
>> >> Cisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version
>> >> 15.0(1)M1, RELEASE SOFTWARE (fc1)
>> >>
>> >> #sh run
>> >> -- some output ommited --
>> >> network-clock-participate wic 1
>> >>
>> >> isdn switch-type primary-qsig
>> >> isdn gateway-max-interworking
>> >>
>> >> voice-card 0
>> >> dsp services dspfarm
>> >> !
>> >> !
>> >> !
>> >> voice class codec 1
>> >> codec preference 1 g729br8
>> >> codec preference 2 g729r8
>> >> !
>> >> !
>> >> controller E1 0/1/0
>> >> framing NO-CRC4
>> >> clock source internal
>> >> pri-group timeslots 1-12,16
>> >> description Enlace E1 com o PABX
>> >> !
>> >> interface GigabitEthernet0/0
>> >> description LAN
>> >> bandwidth 1000000
>> >> ip address 172.26.130.2 255.255.255.192
>> >> ip wccp 61 redirect in
>> >> ip flow ingress
>> >> ip flow egress
>> >> duplex auto
>> >> speed auto
>> >> h323-gateway voip interface
>> >> h323-gateway voip id GK_SEDE_1 ipaddr 172.254.1.3 1719
>> >> h323-gateway voip id GK_SEDE_2 ipaddr 172.254.1.2 1719
>> >> h323-gateway voip h323-id GW_XXXX
>> >> h323-gateway voip tech-prefix 1#
>> >> h323-gateway voip bind srcaddr 172.26.130.2
>> >> service-policy input MARKQoSOUT
>> >>
>> >> !
>> >> interface Serial0/1/0:15
>> >> no ip address
>> >> encapsulation hdlc
>> >> isdn switch-type primary-qsig
>> >> isdn overlap-receiving
>> >> isdn incoming-voice voice
>> >> isdn contiguous-bchan
>> >> no cdp enable
>> >> !
>> >> voice-port 0/1/0:15
>> >> cptone BR
>> >> !
>> >> dial-peer voice 5 pots
>> >> description Internal Extensions to the PBX
>> >> destination-pattern 3396....
>> >> direct-inward-dial
>> >> port 0/1/0:15
>> >> forward-digits 4
>> >> no register e164
>> >> !
>> >> dial-peer voice 13 voip
>> >> description Output dial-peer
>> >> destination-pattern 3.......
>> >> session target ras
>> >> voice-class codec 1
>> >> !
>> >> !
>> >> gateway
>> >> !
>> >> !
>> >> !
>> >> gatekeeper
>> >> shutdown
>> >>
>> >> Guilherme Loch Góes
>> >>
>> >> _______________________________________________
>> >> cisco-voip mailing list
>> >> cisco-voip at puck.nether.net
>> >> https://puck.nether.net/mailman/listinfo/cisco-voip
>> >
>> >
>>
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
More information about the cisco-voip
mailing list