[cisco-voip] ISDN Signaling

[Haas, Neal]

Personally, I would tell them to setup the Switch type exactly the same as the current setup. Keeps it simple for documentation.

Neal Haas

1020 S 10th St
Fresno, CA  93702
Desk 559.600.5890

From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Eric Butcher
Sent: Tuesday, August 17, 2010 10:52 AM
To: Bill; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] ISDN Signaling

Sometimes they use a different switch type and tell you they're using NI-2 when they're really just emulating it, and setting it to NI-2 in the gateway causes quirkiness.  You should set the switch type to whatever the circuit is provisioned to use.  If they're really using DMS-100, use that.  If they say they're provisioning it NI-2, then use that. (primary-ni is what will show up in IOS for NI-2)


Eric Butcher
Cisco Unified Communications Engineer
CDW Professional Services
11711 N Meridian, Ste 225
Carmel, IN  46032
* 317.569.4282 - IP Phone
* 765.744.1458 - Mobile
* eric.butcher at cdw.com<mailto:eric.butcher at cdw.com>
http://www.cdw.com/


From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Bill
Sent: Tuesday, August 17, 2010 1:48 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] ISDN Signaling

I am ordering new circuits from the Telco and we are getting our terminology crossed. They are asking / telling me they will install the circuits as ISDN signaling NI2. I am telling them that we already have 20 circuits from them. All of the existing circuits have ISDN switch-type DMS-100. So is the DMS-100 that is in the Cisco H.323 gateway configuration compatible with NI2? They are using the term ISDN signaling and I am using the term ISDN Switch-type.



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100817/f0ad1bca/attachment.html>