[cisco-voip] OT: Installation cost

[Scott Voll]

Don't know rate for installation.  I'm guessing in the range of $125/hr to
$200/hr

Phase 1


   - CM 40 hours
   - UC 16 hours
   - CUPS not sure
   - UCCx 300 agents?  are you sure you want UCCx?  my understanding is the
   top end with UCCx is 300.  Might need to look at UCCE.  (Really depends on
   Scripting / IVR)  16-???? hours.
   - cucimoc ??  not sure have not done it but guessing around 16 hours if
   all the M$ stuff is ready to go.
   - NEC What kind of connection?  Qsig?  4-?? hours  Is NEC running correct
   version etc.
   - VGW, H323 or MGCP?  2-6hours
   - Phones -- Guessing about 30-45 minutes each if you have them configured
   to unpackage and set on desks.  (I would suggest getting a minimum wage kid
   to do that for you..... save a lot of money).  Depending on features etc.
    the BAT could do it fairly quickly (10-20 minutes each if you include
   scanning all the phones into the speadsheet)
   - ER -- Depends on if everything is ready with the PS-ALI DB vendor.
    16-?? hours
   - Analog -- Wiring can take some time.  Not sure of your setup.  VG's
   lets say 2 hours each?



If you do it right, Phase two should be a bunch of trained monkeys.

Bottom line your looking at a large labor cost.

Scott


On Tue, Aug 17, 2010 at 2:21 PM, Kim Casserly <solarwinds321 at yahoo.com>wrote:

> I know this is a very generic question, but does anyone have a ballpark
> range
> (or percentage of HW cost) of installation costs for a VoIP install? We are
> definitely going to bid out the project, but if installation services are
> over
> "X" amount, we have to jump through some additional hoops. We have a rough
> estimate of what the cost will be for the hardware based upon our usual
> discount
> off list.
>
> The project would essentially consist of:
>
> Phase 1 - VoIP core and Pilot:
>
> Installation / configuration of CUCM (Qty 4: 1 pub, 3 subs)
> Installation, configuration, integration of Unity Connections
> Installation of Presence
> Setup UCCX (~300 agents)
> Integration of Office Communicator through CUCI-MOC
> Integration with existing NEC IMX PBX
> Configuration of four ISR G2 VGs
> Installation of ~300 phones (in pilot)
> Installation, configuration of Emergency Responder
> Initial setup and testing of VG224s
>
>
> Phase 2 - Remaining campus cutover
>
> ~3500 phones
> Phased cut-over based upon building (non-contiguous dial plan in buildings)
> ~1000 analog lines (terminated in four different locations) with use of
> VG224s
>
>
> This would be a single-site deployment, with a fairly homogeneous
> feature-set
> across phones (except for a few small groups requiring ACD & intercoms).
>
>
> Thanks in advance for taking the time to respond. Hopefully, the OT post
> doesn't
> offend anyone :-)
>
> Take care.
>
> -K
>
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100817/91b31faa/attachment.html>