[cisco-voip] Installing CM7.1.2 on MCS 7825-I4 failed

[Ryan Ratliff (rratliff)]

Yup looks like I was mistaken and it's not bootable.  I thought one of
them had made it through to Cisco.com but apparently not.

 

-Ryan

 

From: Ahmed Elnagar [mailto:ahmed_elnagar at rayacorp.com] 
Sent: Wednesday, December 22, 2010 12:05 PM
To: Ryan Ratliff (rratliff); Youssef Shaaban
Cc: cisco-voip voyp list
Subject: RE: [cisco-voip] Installing CM7.1.2 on MCS 7825-I4 failed

 

Are you sure?

The release notes says that it is not bootable.

 

http://www.cisco.com/web/software/282074295/31799/cucm-readme-713bsu2.pd
f 

 

 

 

Best Regards,

Ahmed Elnagar | CCIE#24697 Voice

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Ryan Ratliff
Sent: Wednesday, December 22, 2010 6:15 PM
To: Youssef Shaaban
Cc: cisco-voip voyp list
Subject: Re: [cisco-voip] Installing CM7.1.2 on MCS 7825-I4 failed

 

First of all the doc and bug you reference don't have anything to do
with install failures but patching the hard drive firmware prior to
install is a very good idea.

 

Second I would strongly recommend going to 7.1(5) over 7.1(2) for a new
install.  If you don't have the media handy for 7.1(5) the 7.1(3b)SU2
posted to cisco.com is bootable media that you can use for an install
(just to rule out an issue with your 7.1.2 media).

 

Finally, you can try going in and deleting any existing raid array on
the server to see if that helps get the install moving.  Once it passes
hardware validation the disk setup is the next step.

 

-Ryan

 

On Dec 22, 2010, at 10:51 AM, Youssef Shaaban wrote:

 

I have CM 4.3 running on MCS7825-I4 and I'm trying to upgrade it to
7.1.2 using DMA but during the installation the server stuck at: 

[

7825I4:passed detection validation

Beginning Firware Managment...

Firmware Update: firmware already up-to-date "144"

x3250M2: BIOS Update: execution successfully"

]

and freeze.

I found the following bug:

https://supportforums.cisco.com/docs/DOC-12955

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method
=fetchBugDetails&bugId=CSCti52867

 

So I installed the FWUCD 3.6.1 but got the following errors:
IBM serverRAIDMR10is SAS Controller fir 11.0.1-0033a (not applicable):
update not applicable to this system configuration hardware is not
required
IBM system x3250 M2 remote supervisor adapter II1.05 (install did not
succeed)

 

Best Regards,

Youssef Shaaban | CCIE#24656 Voice.

 

Networking Team Leader

Raya IT - Professional Networking Services

Mobile    : +20108558598

Tel          : +20238276000 Ext. 2451

Fax         : +20238372930

Email      : youssef_shaaban at rayacorp.com
<mailto:Nadia_khalifa at rayacorp.com> 
Address : El Motamayez District - 6th of October
<image001.jpg>

 

Disclaimer: NOTICE The information contained in this message is
confidential and is intended for the addressee(s) only. If you have
received this message in error or there are any problems please notify
the originator immediately. The unauthorized use, disclosure, copying or
alteration of this message is strictly forbidden. Raya will not be
liable for direct, special, indirect or consequential damages arising
from alteration of the contents of this message by a third party or as a
result of any malicious code or virus being passed on. Views expressed
in this communication are not necessarily those of Raya.If you have
received this message in error, please notify the sender immediately by
email, facsimile or telephone and return and/or destroy the original
message. _______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

 

 

Disclaimer: NOTICE The information contained in this message is
confidential and is intended for the addressee(s) only. If you have
received this message in error or there are any problems please notify
the originator immediately. The unauthorized use, disclosure, copying or
alteration of this message is strictly forbidden. Raya will not be
liable for direct, special, indirect or consequential damages arising
from alteration of the contents of this message by a third party or as a
result of any malicious code or virus being passed on. Views expressed
in this communication are not necessarily those of Raya.If you have
received this message in error, please notify the sender immediately by
email, facsimile or telephone and return and/or destroy the original
message. 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20101222/ab9b9c69/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: image001.png
Type: image/png
Size: 8405 bytes
Desc: image001.png
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20101222/ab9b9c69/attachment.png>