[cisco-voip] What is wrong with my destination pattern?

[Nick Matthews]

debug voip ccapi inout will give you some call routing details.

i would suggest debug isdn q931.  if it's going out isdn, isdn is
rejecting it, it will try the next dial peer.

you may also want to create more specific dial peers.

9(011).T
91..........
9........

Like that, for US numbers at least.

-nick

On Tue, Feb 2, 2010 at 10:43 AM, John Lange <john at johnlange.ca> wrote:
> We have a Cisco connected to a PRI acting as a VOIP gateway for an
> Asterisk system. In our setup, we have every call arriving at the
> gateway that begins with "9" routed to the PRI, and everything else
> routed to the Asterisk server.
>
> In short, this means any number starting with "9" should be an outbound
> call (to the PRI), and everything else should be is an inbound call (to
> the Asterisk server).
>
> The problem is, any international call seems to be looping back to the
> Asterisk box. For example, if we dial '9011448712002000' it ends up
> looping back to the Asterisk server as if the Cisco is ignoring the 9.
>
> Here are the dialpeers. Pretty straight forward. What could be wrong?
>
> What commands can I use to trace the progress of a call on the console
> to see why the Cisco is doing this?
>
> ---
>
> dial-peer voice 20 pots
>  destination-pattern 9
>  direct-inward-dial
>  port 0/3/0:23
>  forward-digits extra
> !
> dial-peer voice 40 voip
> preference 1
> destination-pattern .
> session protocol sipv2
> session target ipv4:192.168.134.9
> session transport udp
> dtmf-relay sip-notify rtp-nte
> codec g711ulaw
> fax rate 14400
> fax protocol t38 ls-redundancy 2 hs-redundancy 1 fallback pass-through
> g711ulaw
> no vad
>
> ---
>
>
> --
> John Lange
> http://www.johnlange.ca
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>