[cisco-voip] Internaltional Calls Failing at the Bell PRI

[John Lange]

On Tue, 2010-02-02 at 20:37 -0600, Go0se wrote:
> You do it on the serial interface with an "isdn map address" command. The below config is off of a working CME:
> 
> !
> interface Serial0/0/0:23
>  no ip address
>  encapsulation hdlc
>  isdn switch-type primary-ni
>  isdn incoming-voice voice
>  isdn map address ^011* plan unknown type unknown
>  no cdp enable
> !
> 
> -Go0se

Thanks. Applying it to the interface is a cleaner solution than what I
had before so I prefer this over the translation rules.

-- 
John Lange
http://www.johnlange.ca