[cisco-voip] Both Lines Speed Dial on a 7940

[Jim Reed]

I tried the instructions contained in the attached Cisco document.  If I don't create a DN on the phone, I get an Error Pass Limit when I go off-hook.  If I configure a DN on the phone, I get a busy signal when I go off-hook.  The translation pattern is set to dial a CTI route point into IPCC.  But wouldn't think that would make a difference.

Thank You...
--
Jim Reed
Technology Wrangler
Swift Communications, Inc.
970-683-5646 (Direct)
775-772-7666 (Cell)

"Did Adam and Eve
have navels?"
       --Martin Gardner



On 2/17/10 3:08 PM, "Lelio Fulgenzi" <lelio at uoguelph.ca> wrote:

Rather than a speed dial, make it a PLAR.

---
Lelio Fulgenzi, B.A.
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Cooking with unix is easy. You just sed it and forget it.
                              - LFJ (with apologies to Mr. Popeil)


----- Original Message -----
From: "Jim Reed" <jreed at swiftnews.com>
To: "cisco-voip" <cisco-voip at puck.nether.net>
Sent: Wednesday, February 17, 2010 5:04:36 PM GMT -05:00 US/Canada Eastern
Subject: [cisco-voip] Both Lines Speed Dial on a 7940

Anyone know of a way to make both buttons on a 7940 function as speed dials?
I want to set up a 7940 that no matter which button someone pushes will dial
the route point for a call center.  Everything I can find in Call Manager
shows that Line 1 always has to be a DN.

Thank You...


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100217/4fa3adca/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: config_hotdial.pdf
Type: application/octet-stream
Size: 181377 bytes
Desc: config_hotdial.pdf
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100217/4fa3adca/attachment.obj>