[cisco-voip] h323 PRI two trunk groups

[Carter, Bill]

Yes, this is call NFAS. After the controllers are configured, there is
only 1 serial interface.

 

controller T1 0/0/1

 cablelength long 0db

 pri-group timeslots 1-24 nfas_d primary nfas_int 0 nfas_group 1

!

controller T1 0/1/0

 cablelength long 0db

 pri-group timeslots 1-24 nfas_d backup nfas_int 1 nfas_group 1

!

 

interface Serial0/0/1:23

 no ip address

 encapsulation hdlc

 isdn switch-type primary-ni

 isdn incoming-voice voice

 no cdp enable

!

 

 

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Countryman,
Edward
Sent: Monday, January 04, 2010 10:01 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] h323 PRI two trunk groups

 

I have a vendor who has requested I split up a single PRI into two
separate trunk groups but with only one d channel.  I am not sure if
this can be done or even how.  Anyone have insight on how to do this?

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100104/9396cb66/attachment.html>