[cisco-voip] convert Avaya T1Pri mod pak to Comcast ENS (mpls) thenback to other end Avaya T1Pri Mod Pak

[Gregory Wenzel]

Thankyou Jason, I will do the same and research. Thank you for some
direction.

Greg

On Tue, Jan 5, 2010 at 6:09 PM, Jason Aarons (US) <
jason.aarons at us.didata.com> wrote:

>  I’ve used T-CCS (Transparent Common Channel Signaling ) with Nortel’s
> before, should work for Avaya.
>
> http://www.cisco.com/en/US/docs/ios/12_1t/12_1t3/feature/guide/dt_tccs.html
>
>
>
> While searching I see 12.4.20T added QSIG over IP.  If your Avaya’ss are
> new enough you could QSIG/IP between them
>
>
> http://www.cisco.com/en/US/docs/ios/voice/sip/configuration/guide/tunneling_qsig_ps6441_TSD_Products_Configuration_Guide_Chapter.html#wp1054633
>
>
>
> *From:* cisco-voip-bounces at puck.nether.net [mailto:
> cisco-voip-bounces at puck.nether.net] *On Behalf Of *Gregory Wenzel
> *Sent:* Tuesday, January 05, 2010 3:47 PM
>
> *To:* cisco-voip at puck.nether.net
> *Subject:* [cisco-voip] convert Avaya T1Pri mod pak to Comcast ENS (mpls)
> thenback to other end Avaya T1Pri Mod Pak
>
>
>
> Question for the group...
>
>
>
> My thoughts are that this would be similar to STUN but with voice. Im
> almost embarased asking this but Im having a mental block and wanted to be
> sure this is possible before I quote it and do the work. Im tempted to use
> pdi but asking questions occaisonally comes back to haunt...
>
>
>
>
>
> I know I can use VWIC2-1MFT-T1PRI cards crossover to Avaya PBX T1 Pri cards
> BUT--> then bridge it onto a highspeed mpls Comcast ENS ring (100MB) via the
> 2911 Wan port  and point a route towards Head end HQ using a 3945 (same
> components) with other end VWIC2-1MFT-T1Pri to Avaya T1 Pri on the HQ Avaya
> HQ site. Basically Extending the PRI over an mpls circuit (NOT VOIP) We are
> migrating them off verizon T1 Pri's and onto this ring, Cost savings are
> enormous
>
>
>
> Thank you in advance
>
>
>
> Greg
>
>
>
> ------------------------------
>
> *Disclaimer: This e-mail communication and any attachments may contain
> confidential and privileged information and is for use by the designated
> addressee(s) named above only. If you are not the intended addressee, you
> are hereby notified that you have received this communication in error and
> that any use or reproduction of this email or its contents is strictly
> prohibited and may be unlawful. If you have received this communication in
> error, please notify us immediately by replying to this message and deleting
> it from your computer. Thank you. *
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100105/055b7de9/attachment.html>