[cisco-voip] route outgoing call to FXO based on calling-number

[Brian Schultz]

I'm sure there is a simple command to accomplish this, but I'm not figuring
it out.

I have a 2801 gateway at a remote site with 2 analog FXS phones.  This is
connected by a PTP T1 to another 2801 at HQ with 2 FXO lines to a PBX.  I'm
not using any CallManager, just H323 gateways.  All calling between the
sites is good based off of dial-peers.

The only thing I can't get to work is how to route a call out to a FXO based
on the calling number.  For instance, if a single FXS phone from the remote
gateway trys to dial a 4 digit extension on the PBX, what command do I
configure in the dial-peer to force that call to use FXO port 0/0/0?  I
would want the other FXS phone at the remote gateway to always use the other
FXO port 0/0/1 for outbound calls.  Is there a dial-peer command to filter
or "policy-route" based on the calling-number?

Thanks,
Brian
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100608/10653765/attachment.html>