[cisco-voip] sending calls form a voip dialpeer to another dialpeer

[Mac GroupStudy]

If your router supports the command you don't even need a CUBE. Try the
command I referenced to see if it is supported first. Also consider why you
need to route from one VOIP DP to another. A true CUBE solution maybe your
best bet.

On Tue, Jun 22, 2010 at 4:02 PM, Dew Swen <dew.swen at gmail.com> wrote:

> Other than cube what is needed?
>
> Regards,
>
> --
> Dew Swen
> CCVP, CCNP
>
>
>
>
> On 22.Haz.2010, at 16:32, Mac GroupStudy <mac.groupstudy at gmail.com> wrote:
>
> Prior to CUBE there was a concept of an IP-IP Gateway. It and CUBE requires
> something similar to this:
> config)# voice service voip
> # allow-connections h323 to h323
>
>
> On Tue, Jun 22, 2010 at 8:41 AM, Dew Swen < <dew.swen at gmail.com>
> dew.swen at gmail.com> wrote:
>
>> Could anyone shed on some light about:
>>
>> "What is needed for sending calls from a voip dial-peer to voip dial-peer
>> in a h323 gw?"
>>
>> AFAIK,
>> - CUBE functions must be enabled
>> - MTP must be configured on both CUCM and IOS
>> - Have to do something in CUCM Gateway configuration??
>>
>> Any help or document will be appriciated.
>>
>> Kind regards,
>>
>> --
>> Dew Swen
>> CCVP, CCNP
>>
>>
>> _______________________________________________
>> cisco-voip mailing list
>>  <cisco-voip at puck.nether.net>cisco-voip at puck.nether.net
>>  <https://puck.nether.net/mailman/listinfo/cisco-voip>
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100622/9e023e90/attachment.html>