[cisco-voip] Can I increase paging volume?

[Jason Aarons (US)]

If you plug a phone into the FXS port and call it  does it sound normal?

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Eric Brander
Sent: Monday, June 28, 2010 4:17 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Can I increase paging volume?

I have a Bogen pager attached to an FXS port (VIC3-4FXS/DID) on a 2921 using MGP and the port is configured for Analog Access. I have the volume cranked up on the amplifier for the pager and the initial BING sound from the Bogen is VERY LOUD however the voice that comes across is quiet in comparison. So much so that most people cannot hear the page unless it is near dead silence in the room. I've tried tweaking things on the Bogen but everything I tried got worse, not better. I'm hoping that maybe there's a way in CM to boost the volume or something. Anyone have any suggestions?

Thanks and Regards,

Eric Brander
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

-----------------------------------------
Disclaimer: 

This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only.  If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful.  If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.