[cisco-voip] Can I increase paging volume?

[Haas, Neal]

Quick things to check. Is the person a soft speaker on the phone? Have you tried a different phone? Make sure that the settings are correct for the phone, I think try to turn the gain up on the Bogen. I setup one of these a while back and worked without a hitch. Maybe 20 minutes to set it up.

Neal Haas


-----Original Message-----
From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Eric Brander
Sent: Monday, June 28, 2010 1:17 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Can I increase paging volume?

I have a Bogen pager attached to an FXS port (VIC3-4FXS/DID) on a 2921 using MGP and the port is configured for Analog Access. I have the volume cranked up on the amplifier for the pager and the initial BING sound from the Bogen is VERY LOUD however the voice that comes across is quiet in comparison. So much so that most people cannot hear the page unless it is near dead silence in the room. I've tried tweaking things on the Bogen but everything I tried got worse, not better. I'm hoping that maybe there's a way in CM to boost the volume or something. Anyone have any suggestions?

Thanks and Regards,

Eric Brander
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip