[cisco-voip] Cisco Call Manager E&M

[Martin Bufton]

The 2811 is not configured as a gateway as yet.

 

Therefore I can configure it as an h.323 gateway.

 

Do I then use route patterns to send calls to the h.323 gateway?

 

Regards,

 

 

Martin Bufton BSc (Hons), CCNA - Systems Engineer 

 

From: Jim McBurnett [mailto:jim at tgasolutions.com] 
Sent: 08 March 2010 21:42
To: Leslie Meade; Martin Bufton
Cc: cisco-voip voyp list
Subject: RE: [cisco-voip] Cisco Call Manager E&M

 

If all you want is just that E&M on H.323—

Just make dial-peers for it alone..

 

I have seen that done….

 

A dual-role Gateway.

 

Jim

 

From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Leslie Meade
Sent: Monday, March 08, 2010 12:23 PM
To: Martin Bufton
Cc: cisco-voip voyp list
Subject: Re: [cisco-voip] Cisco Call Manager E&M

 

I gather you have a MGCP gateway J

I had the  same issue, I converted to a H.323 and created dials peers to it and it works fine.

 

Leslie

 

 

 

From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Martin Bufton
Sent: Monday, March 08, 2010 8:43 AM
Cc: cisco-voip voyp list
Subject: [cisco-voip] Cisco Call Manager E&M

 

Have a central site that is running Call Manager 7

 

I have a branch office with a 2811, running SRST.

 

I would like to use the E&M port on the 2811, to interface with an intercom system.

 

How do I go about getting Call Manager to see the E&M module?

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100309/0033c524/attachment.html>