[cisco-voip] H.323 Gateway (Cisco) and Plan Type

[Cristobal Priego]

create a more specific dial peer something like

dial-peer voice 9011 pots
destination-pattern 9011T
port0/0/0:23


by default, the exact match on the destination pattern is ignored when you
send the call out in this case 9011will be ignored and it will send the rest
of the chain out  442075147212
and the call to UK should be good

let me know how it goes

2010/3/10 Matthew Ballard <mballard at otis.edu>

>  Here’s all of the pots dial peers:
> dial-peer voice 1 pots
>  call-block translation-profile incoming call_block
>  call-block disconnect-cause incoming call-reject
>  destination-pattern 9[2-9]......
>  direct-inward-dial
>  port 0/0/0:23
>  prefix 1310
> !
> dial-peer voice 2 pots
>  destination-pattern 9T
>  direct-inward-dial
>  port 0/0/0:23
> !
> dial-peer voice 3 pots
>  call-block translation-profile incoming call_block
>  call-block disconnect-cause incoming call-reject
>  destination-pattern 9[2-9]......
>  direct-inward-dial
>  port 0/0/1:23
>  prefix 1310
> !
> dial-peer voice 4 pots
>  destination-pattern 9T
>  direct-inward-dial
>  port 0/0/1:23
> !
>
> Matthew
>
>
>
> On 3/10/10 3:37 PM, "Cristobal Priego" <cristobalpriego at gmail.com> wrote:
>
> could you show your H.323 dial-peer for international calls
>
> 2010/3/10 Matthew Ballard <mballard at otis.edu>
>
> I had included that in the subject line, it is a H.323 gateway.
>
> Matthew
>
>
>
>
> On 3/10/10 3:32 PM, "Cristobal Priego" <cristobalpriego at gmail.com <
> http://cristobalpriego@gmail.com> > wrote:
>
> is your gateway configured as a MGCP or H.323 gateway ?
>
> 2010/3/10 Matthew Ballard <mballard at otis.edu <http://mballard@otis.edu> >
>
> I ran into a problem with our telephony provider that has been discovered
> as
> of yesterday.  Our system is sending out a Type of International (see
> below)
> when it is connecting a call that begins with 011.  After opening a ticket
> with our provider when trying to call international (at least some of the
> time), there is a problem with sending the 011 and sending the type
> international.  I'm not sure in IOS how to either strip the 011 or change
> the Type being sent (someone else did the initial setup of the gateway).
> Can someone point me in the right direction?
>
> Thank You,
> Matthew Ballard
> Network Manager
> Otis College of Art and Design
> mballard at otis.edu <http://mballard@otis.edu>
>
> .Mar 10 14:15:11.540 PST: ISDN Se0/0/0:23 Q931: pak_private_number: Invalid
> type/plan 0x0 0x0 may be overriden; sw-type 13
> .Mar 10 14:15:11.540 PST: ISDN Se0/0/0:23 Q931: pak_private_number: Invalid
> type/plan 0x0 0x0 may be overriden; sw-type 13
> .Mar 10 14:15:11.540 PST: ISDN Se0/0/0:23 Q931: Applying typeplan for
> sw-type 0xD is 0x1 0x1, Called num 011442075147212
> .Mar 10 14:15:11.544 PST: ISDN Se0/0/0:23 Q931: TX -> SETUP pd = 8  callref
> = 0x6D92
>         Bearer Capability i = 0x8090A2
>                 Standard = CCITT
>                 Transfer Capability = Speech
>                 Transfer Mode = Circuit
>                 Transfer Rate = 64 kbit/s
>         Channel ID i = 0xA98397
>                 Exclusive, Channel 23
>         Calling Party Number i = 0x2181, '3106656929'
>                 Plan:ISDN, Type:National
>         Called Party Number i = 0x91, '011442075147212'
>                 Plan:ISDN, Type:International
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net <http://cisco-voip@puck.nether.net>
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
>
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100310/6391d487/attachment.html>