[cisco-voip] CUCM 7 Send busy signal if number not configured

[Ryan Ratliff]

Get the output of 'debug isdn q931' on the router. 

-Ryan

On May 10, 2010, at 2:45 AM, Reto Gassmann wrote:

> Hello Ryan
> 
> they hear nothing, silence and after 40 seconds I get an anouncement from the telco, that the number is not reachable. The call also does never connect. So if I check on the gateway the call is not listed.
> 
> Reto
> 
> 2010/5/9 Ryan Ratliff <rratliff at cisco.com>
> What do they hear?  4.2(3) had annunciator so unless you changed something around that media resource you should be getting a disconnect cause of unallocated/unassigned number sent back to the gateway, and from there along to the telco.
> 
> -Ryan
> 
> On May 8, 2010, at 5:17 AM, Reto Gassmann wrote:
> 
> > Hello group
> >
> > last night we updated our cucm cluster to Version 7.1(3a).
> > Now we run into the problem, that calls from the PSTN (3750 with PRI Interfaces connect to the CUCM with h.323) to a unknown number don't get the busy signal. The 4.2(3) Cluster did exactly that.
> > Has anyone an idea how we could fix that?
> >
> > Thanks Reto
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
> 
> 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100510/d827e6c0/attachment.html>