[cisco-voip] 6500 802.1x and VOICE VLAN on same port

[John Kougoulos]

Hello,

why don't you run CatOS on Sup2 ?

As far as I can remember, CatOS was the preferred choice for 6500 when 
placed in the access layer. (obviously because native IOS couldn't match 
the features of CatOS at that time). Native IOS didn't support ATM LANE on 
6500 also...

Regards,
John

On Thu, 21 Oct 2010, george.hendrix at l-3com.com wrote:

> 
> Hi everyone,
> 
>  
> 
>   Does anyone know if Cisco plans to change the functionality of 802.1x configured on a 6500 w/ Sup2/MSFC2 engine?  As I
> said below, the current IOS for the Sup2/MSFC2 does not support having both 802.1x and voice vlan configured on the same
> port.  I think it is just crazy that it can be done in CatOS, but not IOS using the same hardware.
> 
>  
> 
> Thanks,
> 
> Bill
> 
>  
> 
> From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of
> george.hendrix at l-3com.com
> Sent: Wednesday, October 20, 2010 9:16 AM
> To: cisco-voip at puck.nether.net
> Subject: [cisco-voip] 6500 802.1x and VOICE VLAN on same port
> 
>  
> 
> Hi everyone,
> 
>  
> 
>   I am looking at swapping out some old 6500 Supervisor 1 engines running CatOS with some Supervisor 2 engines running
> IOS (12.2 SXD train).  After starting the configuration, I quickly noticed that I cannot configure both 802.1x and voice
> vlan on the same interface.  But this seemed to work just fine with dot1x and aux VLAN in CatOS on the Sup1.  Does anyone
> know if there are plans to make this work on the Sup 2 IOS?  I believe it is supported with Supervisor 720s running IOS
> 12.2(33)SXH or higher.
> 
>  
> 
> This is the link where I read “The 802.1X protocol is not supported on ports configured with voice VLAN.”
> 
>  
> 
> http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SXF/native/configuration/guide/dot1x.html#wp1044550
> 
>  
> 
> Thanks,
> 
> Bill
> 
>  
> 
> 
>