[cisco-voip] 6500 802.1x and VOICE VLAN on same port

[george.hendrix at l-3com.com]

Hi everyone,

 

  Does anyone know if Cisco plans to change the functionality of 802.1x
configured on a 6500 w/ Sup2/MSFC2 engine?  As I said below, the current
IOS for the Sup2/MSFC2 does not support having both 802.1x and voice
vlan configured on the same port.  I think it is just crazy that it can
be done in CatOS, but not IOS using the same hardware.

 

Thanks,

Bill 

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of
george.hendrix at l-3com.com
Sent: Wednesday, October 20, 2010 9:16 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] 6500 802.1x and VOICE VLAN on same port

 

Hi everyone,

 

  I am looking at swapping out some old 6500 Supervisor 1 engines
running CatOS with some Supervisor 2 engines running IOS (12.2 SXD
train).  After starting the configuration, I quickly noticed that I
cannot configure both 802.1x and voice vlan on the same interface.  But
this seemed to work just fine with dot1x and aux VLAN in CatOS on the
Sup1.  Does anyone know if there are plans to make this work on the Sup
2 IOS?  I believe it is supported with Supervisor 720s running IOS
12.2(33)SXH or higher.

 

This is the link where I read "The 802.1X protocol is not supported on
ports configured with voice VLAN."

 

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SXF/na
tive/configuration/guide/dot1x.html#wp1044550

 

Thanks,

Bill 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20101021/6b659a0c/attachment.html>