[cisco-voip] destination-pattern #880$

[Nelson, Mike]

Hi all,

I am using a UCM 6.1(4) with H323 gateway.     I have a RP of #880 that I send to the H323 gateway, a 2951 running 15.1(1)T.   This matches the dial-peer shown below and is routed out an FXO port:

dial-peer voice 20 pots
 description ***Paging Interface - ALL Page***
 destination-pattern #880$
 port 0/3/2
 forward-digits 0
 prefix 0

In normal operation, the call is routed as I would expect with a 0 being sent to the paging system.    This is also an SRST gateway and when attached SRST phone dial the same pattern, the call fails after I dial #8.

If I run a debug voice ccapi inout, I see that the pound is being seen as the character T in the debug.    A debug voice dialpeer shows that the call fails to find a matching dial-peer.

I have searched high and low on the Cisco site and in Netpro, and I think that I should be OK with the pound in the destination-pattern, but I must be missing something here...

Any help would be greatly appreciated.

Thanks,

Mike
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20100916/593c119f/attachment.html>