[cisco-voip] MTP won't register

[Adel Abushaev]

Try to configure them as an IOS Enhanced MTP and reset them after you
configure them, then do "no sccp", "sccp" on the router.

Is your Sub in sync with Pub?

A.


On Mon, Apr 18, 2011 at 12:11 PM, Brian Schultz <bms314 at gmail.com> wrote:
> I've tried as both IOS Media Termination Point and IOS Enhanced Media
> Termination Point.  Rebuilt router config after each and reset in CUCM, same
> issue.
>
> I can telnet to both CUCM IP's on port 2000 just fine from the router and
> don't have any firewalls in between.
>
> Thanks,
> Brian
>
>
> On Mon, Apr 18, 2011 at 2:06 PM, Bernhard Albler <bernhard.albler at gmail.com>
> wrote:
>>
>> Did you actually configure it on CCM as a IOS Media Termination Point
>> or  IOS _Enhanced_ Media Termination Point? You definitely need the
>> latter for PVDM2s and PVDM3s.
>> Not sure if you would see the TC_Conn Error in the case.
>> Can you telnet to port 2000 on the UCM from the router?
>>
>> regards
>> bernhard
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>