[cisco-voip] Taipei PSTN / ChungHwa PRI setup

Matthew Berry matthew.berry at cdw.com
Tue Aug 30 13:02:11 EDT 2011


After changing the switch type to NET5, did it resolve the issue?

Thanks!

Matthew Berry, CCIE #26721 (Voice)
CDW | Sr. Unified Communications Engineer
Single Number Reach: +1.763.592.5987
Email:  matthew.berry at cdw.com


From: Chase Mergenthal <chase at nothingbutnetllc.com<mailto:chase at nothingbutnetllc.com>>
Date: Tue, 30 Aug 2011 11:35:28 -0500
To: Nate VanMaren <VanMarenNP at ldschurch.org<mailto:VanMarenNP at ldschurch.org>>
Cc: voip puck <cisco-voip at puck.nether.net<mailto:cisco-voip at puck.nether.net>>
Subject: Re: [cisco-voip] Taipei PSTN / ChungHwa PRI setup

After some troubleshooting this morning; I found that the switch type is
net5 and NOT ni2....

-Chase

On 8/29/2011 6:10 PM, Nate VanMaren wrote:
My guess is that you're setting the type and plan to ISDN/InterNational and sending the prefix digits to the carrier.  Either strip the digits that prefix an international dialing string or set the type and plan to Unknown/Unknown.

-Nate

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net<mailto:cisco-voip-bounces at puck.nether.net> [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Chase Mergenthal
Sent: Monday, August 29, 2011 4:04 PM
To: voip puck
Subject: [cisco-voip] Taipei PSTN / ChungHwa PRI setup

Hello,
               I'm am trying to setup a PRI in Taipei with ChungHwa telecom. I believe I have the circuit configured correctly as the circuit is up. But when I try to place test calls I get a "unassigned number" back from the carrier. So I am assuming I am sending incorrect digits to the carrier. My test call is to '002 1 952 xxx xxxx'; ive tried sending different combinations of digits to the ChungHwa with the same result:

Aug 22 08:03:36.279 CST: ISDN Se0/0/0:23 Q931: RX<- DISCONNECT pd = 8 callref = 0x887A
           Cause i = 0x8281 - Unallocated/unassigned number
           Progress Ind i = 0x8488 - In-band info or appropriate now available
           Progress Ind i = 0x8282 - Destination address is non-ISDN


Any ideas?

-Chase
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net<mailto:cisco-voip at puck.nether.net>
https://puck.nether.net/mailman/listinfo/cisco-voip


   NOTICE: This email message is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply email and destroy all copies of the original message.



_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net<mailto:cisco-voip at puck.nether.net>
https://puck.nether.net/mailman/listinfo/cisco-voip

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20110830/37c50804/attachment.html>


More information about the cisco-voip mailing list