[cisco-voip] Taipei PSTN / ChungHwa PRI setup

[Chase Mergenthal]

After some troubleshooting this morning; I found that the switch type is 
net5 and NOT ni2....

-Chase

On 8/29/2011 6:10 PM, Nate VanMaren wrote:
> My guess is that you're setting the type and plan to ISDN/InterNational and sending the prefix digits to the carrier.  Either strip the digits that prefix an international dialing string or set the type and plan to Unknown/Unknown.
>
> -Nate
>
> -----Original Message-----
> From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Chase Mergenthal
> Sent: Monday, August 29, 2011 4:04 PM
> To: voip puck
> Subject: [cisco-voip] Taipei PSTN / ChungHwa PRI setup
>
> Hello,
>               I'm am trying to setup a PRI in Taipei with ChungHwa telecom. I believe I have the circuit configured correctly as the circuit is up. But when I try to place test calls I get a "unassigned number" back from the carrier. So I am assuming I am sending incorrect digits to the carrier. My test call is to '002 1 952 xxx xxxx'; ive tried sending different combinations of digits to the ChungHwa with the same result:
>
> Aug 22 08:03:36.279 CST: ISDN Se0/0/0:23 Q931: RX<- DISCONNECT pd = 8 callref = 0x887A
>           Cause i = 0x8281 - Unallocated/unassigned number
>           Progress Ind i = 0x8488 - In-band info or appropriate now available
>           Progress Ind i = 0x8282 - Destination address is non-ISDN
>
>
> Any ideas?
>
> -Chase
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
>   NOTICE: This email message is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply email and destroy all copies of the original message.
>
>