[cisco-voip] Taipei PSTN / ChungHwa PRI setup

[Nate VanMaren]

My guess is that you're setting the type and plan to ISDN/InterNational and sending the prefix digits to the carrier.  Either strip the digits that prefix an international dialing string or set the type and plan to Unknown/Unknown.

-Nate

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Chase Mergenthal
Sent: Monday, August 29, 2011 4:04 PM
To: voip puck
Subject: [cisco-voip] Taipei PSTN / ChungHwa PRI setup

Hello,
             I'm am trying to setup a PRI in Taipei with ChungHwa telecom. I believe I have the circuit configured correctly as the circuit is up. But when I try to place test calls I get a "unassigned number" back from the carrier. So I am assuming I am sending incorrect digits to the carrier. My test call is to '002 1 952 xxx xxxx'; ive tried sending different combinations of digits to the ChungHwa with the same result:

Aug 22 08:03:36.279 CST: ISDN Se0/0/0:23 Q931: RX <- DISCONNECT pd = 8 callref = 0x887A
         Cause i = 0x8281 - Unallocated/unassigned number
         Progress Ind i = 0x8488 - In-band info or appropriate now available
         Progress Ind i = 0x8282 - Destination address is non-ISDN


Any ideas?

-Chase
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip


 NOTICE: This email message is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply email and destroy all copies of the original message.