[cisco-voip] dial peer question

Thu Feb 10 12:29:09 EST 2011

I tried removing the prefix from the last email and still nothing.  If I write a rule that’s destination-pattern 911 and run 'show dialplan number 911' and it says no matches  I have tried several other patters like 9T 9.........., etc and so far I can't get it to match any number outbound.  The 2 transition rules were just for testing to make sure it worked.  Am I just doing something fundamentally wrong?

-----Original Message-----
From: Paul [mailto:asobihoudai at yahoo.com] 
Sent: Thursday, February 10, 2011 10:23 AM
To: Aaron Quin; Joel Perez
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] dial peer question

The simple answer here is that you don't have a destination-pattern that matches 
'3035551212' which is why IOS is saying there's no match for the number.
Also I'm a little puzzled why you've configured two translation rules for 2203 
and 2201. If I'm correct, you've configured two rule sets that say change 2203 
to 2203 and 2201 to 2201. 

________________________________
From:Aaron Quin <aquin at ibrtek.com>
To:Joel Perez <tman701 at gmail.com>
Cc:"cisco-voip at puck.nether.net" <cisco-voip at puck.nether.net>
Sent: Thu, February 10, 2011 9:10:13 AM
Subject: Re: [cisco-voip] dial peer question

Ok, here is my config’s dial peer section sections, and the wacky section is 
that the inbound works fine, I can call my did numbers for the configured 2 
stations and they work great, but nothing works outbound.  If I do a show 
dialplan number 3035551212 it says no match for any number I try.  Sorry for the 

long config I cut my VPN stuff out

!
!
voice translation-rule 1
 rule 1 /^2203$/ /2203/
!
voice translation-rule 2
 rule 1 /^2201$/ /2201/
!
!
voice translation-profile Angela_Inbound_2
 translate called 2
!
voice translation-profile Spaceco_Inbound_1
 translate called 1
!
!
controller T1 0/2/0
 cablelength long 0db
 pri-group timeslots 1-24
 description XO_PRI
!
!
!
!
!
interface GigabitEthernet0/0
 no ip address
 duplex full
 speed 100
!
interface GigabitEthernet0/0.10
 encapsulation dot1Q 10
 ip address 10.1.2.1 255.255.255.0
!
interface GigabitEthernet0/0.50
 encapsulation dot1Q 50
 ip address 10.1.1.1 255.255.255.0
 ip nat inside
 ip virtual-reassembly
!
interface GigabitEthernet0/1
 description $ETH-WAN$
 ip address XX.XX.XX.XX 255.255.255.224
 ip nat outside
 ip virtual-reassembly
 duplex full
 speed 100
 crypto map SDM_CMAP_1
!
interface Serial0/2/0:23
 description XO_PRI
 no ip address
 encapsulation hdlc
 isdn switch-type primary-ni
 isdn incoming-voice voice
 no cdp enable
!
interface Integrated-Service-Engine1/0
 ip address 192.168.100.1 255.255.255.252
 service-module ip address 192.168.100.2 255.255.255.252
 !Application: CUE Running on NME
 service-module ip default-gateway 192.168.100.1
 no keepalive
!
voice-port 0/2/0:23
 description XO_PRI
!
voice-port 0/3/0
!
voice-port 0/3/1
!
voice-port 0/3/2
!
voice-port 0/3/3
!
!
!
!
!
dial-peer voice 5000 voip
 destination-pattern 5000
 session protocol sipv2
 session target ipv4:192.168.100.2
 dtmf-relay sip-notify
 codec g711ulaw
 no vad
!
dial-peer voice 2 pots
 description Aaron_Inbound
 translation-profile incoming Spaceco_Inbound_1
 incoming called-number 2203
 direct-inward-dial
 port 0/2/0:23
!
dial-peer voice 3 pots
 description Angela Inbound
 translation-profile incoming Angela_Inbound_2
 incoming called-number 2201
 direct-inward-dial
 port 0/2/0:23
!
dial-peer voice 1 pots
 destination-pattern 9[2-9].........
 port 0/2/0:23
 prefix 9
!
!
!
!
telephony-service
 no auto-reg-ephone
 authentication credential administrator c at ng3t1n
 max-ephones 45
 max-dn 100
 ip source-address 10.1.2.1 port 2000
 calling-number initiator
 url services http://phone-xml.berbee.com/menu.xml
 url authentication http://192.168.100.1/CCMCIP/authenticate.asp
 load 7960-7940 P00308000500
 load 7965 SCCP45.8-5-4S
 time-zone 6
 voicemail 5000
 max-conferences 8 gain -6
 moh flash:/music-on-hold.au
 web admin system name administrator secret 5 $1$DOsT$6q3CUwQ8s9RlQdM4o.Y4a/
 dn-webedit
 time-webedit
 transfer-system full-consult
 directory entry 1 303-475-1614 name Aaron Cell
 create cnf-files version-stamp 7960 Feb 09 2011 09:13:19
!
!
ephone-dn  1  dual-line
 number 2202
 pickup-group 1101
 description Jill
 name Jill Kreissler
 call-forward busy 5000
 call-forward noan 5000 timeout 10
!
!
ephone-dn  2  dual-line
 number 1269
 pickup-group 1101
 description Kenneth
 name Kenneth Ryckeley
 call-forward busy 5000
 call-forward noan 5000 timeout 10
!
!
ephone-dn  3  dual-line
 number 2203
 pickup-group 1101
 description Aaron
 name Aaron Quin
 call-forward busy 5000
 call-forward noan 5000 timeout 10
!
ephone-dn  4  dual-line
 number 2201
 pickup-group 1101
 description Angela
 name Angela Kirkpatrick
 call-forward busy 5000
 call-forward noan 5000 timeout 10
!
!
ephone-dn  5  dual-line
 number 1266
 pickup-group 1101
 description Darcy
 name Darcy Firkus
 call-forward busy 5000
 call-forward noan 5000 timeout 10
!
!
ephone-dn  6  dual-line
 number 1260
 pickup-group 1101
 description Connie
 name Connie Chang
 call-forward busy 5000
 call-forward noan 5000 timeout 10
!
!
ephone-dn  7  dual-line
 number 10000
 label Aaron Ephone
 call-forward busy 5000
!
!
ephone-dn  8  dual-line
 number 8511
 label Jennifer Byrd
 name Jennifer Byrd
 call-forward busy 5000
 call-forward noan 5000 timeout 10
!
!
ephone-dn  31
 number 3001
 park-slot timeout 30 limit 3
!
!
ephone-dn  32
 number 3002
 park-slot timeout 30 limit 3
!
!
ephone-dn  33
 number 3003
 park-slot timeout 30 limit 3
!
!
ephone-dn  34
 number 3004
 park-slot timeout 30 limit 3
!
!
ephone-dn  35
 number 3005
 park-slot timeout 30 limit 3
!
!
ephone-dn  99
 number 5001....
 mwi off
!
!
ephone-dn  100
 number 5002....
 mwi on
!
!
ephone  1
 device-security-mode none
 mac-address 0012.0138.3D44
 username "Jill" password auy81781
 type 7960
 button  1:1
!
!
!
ephone  2
 device-security-mode none
 mac-address 000D.299D.3D8C
 username "Kenneth" password dpe85133
 type 7960
 button  1:2
!
!
!
ephone  3
 device-security-mode none
 mac-address D057.4CF7.8EC0
 username "aquin" password password
 speed-dial 1 1269 label "test"
 type 7965
 button  1:3
!
!
!
ephone  4
 device-security-mode none
 mac-address 0013.7F38.9E24
 username "Angela" password ypb04473
 type 7960
 button  1:4
!
!
!
ephone  5
 device-security-mode none
 mac-address D057.4CF7.91F8
 username "darcy" password spv27189
 type 7965
 button  1:5
!
!
!
ephone  6
 device-security-mode none
 mac-address 0016.46CB.5115
 username "connie" password 123456
 type 7960
 button  1:6
!
!
!
ephone  7
 device-security-mode none
 mac-address 001D.0939.026C
 type CIPC
 button  1:7
!
!
!
ephone  8
 device-security-mode none
 mac-address 0014.A923.950E
 username "jbyrd"
 type 7960
 button  1:8
!
!
!

From:Joel Perez [mailto:tman701 at gmail.com] 
Sent: Thursday, February 10, 2011 9:34 AM
To: Aaron Quin
Cc:cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] dial peer question

We need some more info to know what is going on.
Where are you running the test from, etc....
Pasting the config would help.

Joel P
On Thu, Feb 10, 2011 at 10:53 AM, Aaron Quin <aquin at ibrtek.com> wrote:
I have a question and I’m hoping somebody can help, cause I’m stumped.  I’m 
doing a new installation into an existing site with a PRI and no matter how I 
write the outbound dial peers, nothing matches.  I can even create one that’s a 
full number like 303xxxxxxx and when I test it it says no match.  I also tried 
it for 911 too, if I set up a dial peer for 911, and then dial 911 it doesn’t 
match.  I can post my config if somebody wants it, but anybody have any ideas?

Aaron Quin
Spaceco Business Solutions

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip