[cisco-voip] cube g729 codec

[Noel Yabao]

Hi James,

I did a "codec g729r8" on all dial-peer configurations here, and It just
didn't show up
via the show run command.  Are there other ways to force the codec and/or
disable any
codec negotiation?

Thank you.

On Thu, Feb 10, 2011 at 9:23 PM, Buchanan, James <jbuchanan at presidio.com>wrote:

> Hello,
>
> I don’t see a line where the codec is forced.
>
>
>
> Thanks,
>
>
>
> *James Buchanan *|* Technology Manager, UC *| *South Region *|* Presidio
> Networked Solutions
> 12 Cadillac Dr, Suite 130, Brentwood, TN 37027 *|* **
> jbuchanan at presidio.com <jbuchanan at ctiusa.com>
> **D: 615-866-5729* | *F:* *615-866-5781* | *www.presidio.com*
>
> *CCIE #25863, Voice*
>
>
>
> *From:* cisco-voip-bounces at puck.nether.net [mailto:
> cisco-voip-bounces at puck.nether.net] *On Behalf Of *Noel Yabao
> *Sent:* Thursday, February 10, 2011 6:26 AM
> *To:* cisco-voip at puck.nether.net
> *Subject:* [cisco-voip] cube g729 codec
>
>
>
> Hi,
>
> I was wondering why a 3745 cube would show g729ar8 and not the configured
> g729r8
> on the "show call active voice compact" result.
>
> #AS5400
>    3082649 ANS     T11     g729r8      TELE  P4267
>    3082650 ORG     T11     g729r8      VOIP  2874  10.10.10.16:17956
>
> #3745
>          9 ANS     T11    g729ar8     VOIP        P4267
> 192.168.0.120:17314
>         10 ORG     T11    g729r8      VOIP        P2874
> 172.16.10.27:2344
>
>
> I have forced g729r8 on all peers.  Below is my setup.
>
> AS5400 --> 3745 --> avaya
>
> ---------------------------------------------
> #AS5400 (192.168.0.120)
> dial-peer voice 1 voip
>  destination-pattern 2874
>  progress_ind setup enable 3
>  session target ipv4:10.10.10.16
>  dtmf-relay h245-alphanumeric
>  no vad
>
> #3745 (10.10.10.16)
> dial-peer voice 1 voip
>  destination-pattern 2874
>  session target ipv4:172.16.10.26
>  incoming called-number 2874
>  dtmf-relay h245-alphanumeric
>  no vad
>
> flash:c3745-adventerprisek9-mz.124-15.T8.bin
>
> #AVAYA control (172.16.10.26)
> #AVAYA media (172.16.10.27)
> ----------------------------------------------------
>
> Also attached is the h245 asn1 debug.
>
>
> Is there a way to correct this?
>
>
>
> Thanks and Regards.
>
>
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20110211/f4a99db4/attachment.html>