[cisco-voip] Caller ID FXO Port

[David Zhars]

I believe this has changed with CUCM 8.0.
Under new features for 8.0 is this:

• MGCP signaling and control to selected Cisco VoIP gateways

– Caller ID for PRI and FXO


So it sure seems like it should work.  I have enabled Caller ID in UCM, I
have added caller-id enable on the 2801 under the voice-port config.  Still
no CID showing up.  Might be time to call in the phone co.


I was hoping there was some sort of command I could issue on the 2801 when I
called, that would show me the caller ID of my cell (if it was being
delivered by the phone co).  2801 is running IOS 15.0(1)M4

On Fri, Feb 11, 2011 at 3:08 PM, Saboor Khan <saboor.khan at gmail.com> wrote:

> It should be enable under Voice Port for FXO, command as
>
> caller-id enable
>
> Also checked with your Telco is that they enable on their end as well as.
>
>
> Also something if you are using MGCp for FXO, Caller deos not works, it
> only works with H323, you need to change it to H323 Gateway.
>
> *Symptoms:*
>
> You can potentially encounter this list of symptoms when you configure
> Cisco CallManager with Cisco IOS MGCP gateways with analog FXO and FXS
> ports:
>
>    -
>
>    The MGCP gateway does not register with Cisco CallManager. Refer to MGCP
>    Gateway Registration Failure with Cisco CallManager<http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00805a316c.shtml>
>    .
>    -
>
>    Caller ID does not work on FXO ports. This is because caller ID is not
>    supported with FXO ports when configured for MGCP. Configure the gateway in
>    H.323 mode instead.
>    -
>
>    Overhead paging locks up FXO ports during hookflash unless users go
>    completely off-hook. Shut followed by No shut resets the port. This is
>    related to Cisco bug ID CSCef62275<http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCef62275>(
>    registered <http://tools.cisco.com/RPF/register/register.do> customers
>    only) when fixed in Cisco IOS Software Release 12.3(14)T and later.
>
>
>
> regards
>
> -Saboor
>
> On Fri, Feb 11, 2011 at 1:32 PM, Paul <asobihoudai at yahoo.com> wrote:
>
>> I think you may still have to configure the voice port 'callerid enable'.
>> I
>> remember a few years ago when I configured this on the port for CCME, the
>> customer wasn't paying for callerID and this caused callers to hear
>> ringback
>> twice before the phone actually rang on the customer's side.
>>
>> I don't know if you're required to configure callerID on the FXO port but
>> I'd
>> think that unless MGCP automagically put that command on the port, I doubt
>> your
>> callerID is going to work.
>>
>> ________________________________
>> From:David Zhars <dzhars at gmail.com>
>> To:Paul <asobihoudai at yahoo.com>; cisco-voip at puck.nether.net
>> Sent: Fri, February 11, 2011 10:22:42 AM
>> Subject: Re: [cisco-voip] Caller ID FXO Port
>>
>> Hmmm..no I have not!  I did not know if I had to do this with the router
>> being
>> in MGCP mode.
>> Are the commands the same as for a H323 setup?
>>
>>
>> On Fri, Feb 11, 2011 at 1:17 PM, Paul <asobihoudai at yahoo.com> wrote:
>>
>> Have you configured the FXO port on the router for caller ID?
>> >
>> >
>> >
>> >________________________________
>> >From:David Zhars <dzhars at gmail.com>
>> >To:cisco-voip at puck.nether.net
>> >Sent: Fri, February 11, 2011 9:47:04 AM
>> >Subject: [cisco-voip] Caller ID FXO Port
>> >
>> >
>> >Call Manager 8.0.  MGCP 2801 Router.  Line comes in to first FXO port, we
>> have
>> >Caller ID on the line.
>> >
>> >In CM, I have "Enable Caller ID" set under device information.
>> >
>> >Yet all calls come in without caller ID (just "External Call - Unknown
>> Number"
>> >shows up on the phones).
>> >
>> >Is there a way to see if the 2801 gets the Caller ID?  Or any other
>> >troubleshooting I can do?
>> >
>> >Thanks.
>> >
>> >
>> >
>> >
>> >
>>
>>
>>
>>
>> _______________________________________________
>> cisco-voip mailing list
>>
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20110211/0b5ea2e0/attachment.html>