[cisco-voip] Mapping outbound call to unqiue FXO port IN SRST mode

[Nick Matthews]

You're looking at CME as SRST.

You would do provisioning mode srst phone to keep the phone
configurations.  Then you can apply corlists to the dial peers and
ephones to get this behavior.

-nick

On Wed, Jul 6, 2011 at 10:43 AM, Roger Wiklund <roger.wiklund at gmail.com> wrote:
> Hey
>
> I've used Ciscos recommendation to map outbound calls from different
> IP Phones to specific FXO ports. This is to have the same inbound and
> outbound CLI etc.
>
> http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00801bc341.shtml
>
> However, I have not yet found a way to accomplish this in SRST mode. I
> can make outbound calls in SRST mode, but the phone to FXO port
> mapping is wrong because it just takes the first available FXO port
> from my trunkgroup config.
>
> I have not found any way to match on answer address when a phone is in
> SRST mode. Do you guys know any way around this?
>
> Thanks,
>
> Regards
> Roger
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>