[cisco-voip] PRI Wont Register!!

[Fuermann, Jason]

Since ISDN show multi-frame, and CM shows unkown, I would try clicking reset in the CM. I’ve had that fix more than a few problems that were similar. Short of that we would need the answers to Chris’s questions

From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Chris Ward (chrward)
Sent: Wednesday, August 15, 2012 11:42 AM
To: Countryman, Edward; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] PRI Wont Register!!

Are you trying to use MGCP? Or is this H323/SIP? Can you share a sanitized GW config with us?

+Chris
Unity Connection TME

From: cisco-voip-bounces at puck.nether.net<mailto:cisco-voip-bounces at puck.nether.net> [mailto:cisco-voip-bounces at puck.nether.net]<mailto:[mailto:cisco-voip-bounces at puck.nether.net]> On Behalf Of Countryman, Edward
Sent: Wednesday, August 15, 2012 12:09 PM
To: cisco-voip at puck.nether.net<mailto:cisco-voip at puck.nether.net>
Subject: [cisco-voip] PRI Wont Register!!

Im on a jobsite installing new 2951 with two port VWIC2-2mft-t1  being used to connect via PRI to an existing Nortel CS1000

The gateway shows as registered to CCM and both PRI’s have “multiple frames established” but the PRI’s show as UNKNOWN in the CCM admin pages.

No errors on the PRI connections, CCM is configured as network and the switch type is DMS100.

I am stumped, any ideas from anyone????

(Going to open TAC case but that may be hours)
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20120815/43459113/attachment.html>