[cisco-voip] Question about what I'm doing wrong trying to	block these calls on H.323 ??
    Tim Reimers 
    treimers at ashevillenc.gov
       
    Fri May  4 14:11:02 EDT 2012
    
    
  
Thanks! 
 
I wondered if it was a directionality thing..
 
I just needed this:
 
dial-peer voice 1 pots
incoming called-number .
call-block translation-profile incoming call_block
call-block disconnect-cause incoming call-reject
direct-inward-dial
port 0/0/0:23
!
dial-peer voice 2 pots
call-block translation-profile incoming call_block
call-block disconnect-cause incoming call-reject
incoming called-number .
direct-inward-dial
port 0/0/1:23
 
 
 
From: miken miken [mailto:miken at sisna.com] 
Sent: Friday, May 04, 2012 12:47 PM
To: Tim Reimers
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Question about what I'm doing wrong trying to
block these calls on H.323 ??
 
Hello Tim
 
Your profile has been configured as incoming on your dial-peer for CUCM.
In other words, this will catch the digits inbound from CUCM and not the
PRI. Try configuring the profile incoming on your inbound dial-peer from
the PRI. If you don't have one configured and are using the implicit
dial-peer 0, then perhaps adding it to the voice-port may work with out
having to make additional dial-peer changes to your working
configuration.
 
Thank you
MikeN
 
On Fri, May 4, 2012 at 9:15 AM, Tim Reimers <treimers at ashevillenc.gov>
wrote:
Hi all -
 
I'm having some difficulty in getting call blocking to work -
Calls from 8282438594 to 8282595512 still get through.
AT&T gives me "8282438594" as my incoming number, and delivers "5512" as
my called number.
 
 
Per
http://www.cisco.com/en/US/customer/tech/tk652/tk90/technologies_configu
ration_example09186a00803f818a.shtml#con13
I've done the steps in that section.
 
Only difference is that I'm using a VOIP dialpeer and they show POTS
peers.
The syntax at the top of the section does seem to indicate that either
"pots|voip"
would be legal syntax though.
 
Here's the setup -
 
ISDN PRI connecting to UCM via H.323
Router running 
c2800nm-spservicesk9-mz.123-11.T8.bin
 
UCM is version 7.15
 
 
Here's my setup
 
 
 
voice translation-profile call_block
translate calling 2
 
 
voice translation-rule 2
rule 1 reject /8282438594/
!
!
!
 
 
 
dial-peer voice 1000 voip
description Inbound from PRI to Callmanager2
call-block translation-profile incoming call_block
call-block disconnect-cause incoming call-reject
preference 1
destination-pattern [2-8]...
progress_ind setup enable 3
modem passthrough nse codec g711ulaw
voice-class codec 1
voice-class h323 1
session target ipv4:192.168.201.6
incoming called-number .
dtmf-relay h245-alphanumeric
fax rate disable
no vad
!
dial-peer voice 1001 voip
description Inbound from PRI to Callmanager1
call-block translation-profile incoming call_block
call-block disconnect-cause incoming call-reject
preference 2
destination-pattern [2-8]...
progress_ind setup enable 3
modem passthrough nse codec g711ulaw
voice-class codec 1
voice-class h323 1
session target ipv4:192.168.200.2
incoming called-number .
dtmf-relay h245-alphanumeric
fax rate disable
no vad
 
 
 
Here's a debug ISDN Q931 -
 
Looks like I've got the right "calling number" set- 
 
 
CityHall2821#
002283: 10w2d: ISDN Se0/0/0:23 Q931: RX <- SETUP pd = 8  callref =
0x1CC6
        Bearer Capability i = 0x8090A2
                Standard = CCITT
                Transer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA98382
                Exclusive, Channel 2
        Progress Ind i = 0x8283 - Origination address is non-ISDN
        Calling Party Number i = 0x2183, '8282438594'
                Plan:ISDN, Type:National
        Called Party Number i = 0x80, '5512'
                Plan:Unknown, Type:Unknown
002284: 10w2d: ISDN Se0/0/0:23 Q931: TX -> CALL_PROC pd = 8  callref =
0x9CC6
        Channel ID i = 0xA98382
                Exclusive, Channel 2
CityHall2821#
 
 
Dialplan testing seems to indicate that the call is hitting the
dial-peers where I've got that translation profile configured.
 
 
CityHall2821#sh dialplan number 8282438594
Macro Exp.: 8282438594
 
VoiceOverIpPeer1000
        peer type = voice, information type = voice,
        description = `Inbound from PRI to Callmanager2',
        tag = 1000, destination-pattern = `[2-8]...',
        answer-address = `', preference=1,
        CLID Restriction = None
        CLID Network Number = `'
        CLID Second Number sent
        CLID Override RDNIS = disabled,
        source carrier-id = `', target carrier-id = `',
        source trunk-group-label = `',  target trunk-group-label = `',
        numbering Type = `unknown'
        group = 1000, Admin state is up, Operation state is up,
        incoming called-number = `.', connections/maximum = 6/unlimited,
        DTMF Relay = enabled,
        modem transport = passthrough, nse, payload type = 100, codec =
g711ulaw,
,
        URI classes:
            Incoming (Called) =
            Incoming (Calling) =
            Destination =
        huntstop = disabled,
       in bound application associated: 'DEFAULT'
        out bound application associated: ''
        dnis-map =
        permission :both
        incoming COR list:maximum capability
        outgoing COR list:minimum requirement
        Translation profile (Incoming):
        Translation profile (Outgoing):
        incoming call blocking:
        translation-profile = `call_block'
        disconnect-cause = `call-reject'
        advertise 0x40 capacity_update_timer 25 addrFamily 4
oldAddrFamily 4
        type = voip, session-target = `ipv4:192.168.201.6',
        technology prefix:
        settle-call = disabled
        ip media DSCP = ef, ip signaling DSCP = af31,
        ip video rsvp-none DSCP = af41,ip video rsvp-pass DSCP = af41
        ip video rsvp-fail DSCP = af41,
        UDP checksum = disabled,
        session-protocol = cisco, session-transport = system,
        req-qos = best-effort, acc-qos = best-effort,
        req-qos video = best-effort, acc-qos video = best-effort,
        req-qos audio def bandwidth = 64, req-qos audio max bandwidth =
0,
        req-qos video def bandwidth = 384, req-qos video max bandwidth =
0,
        dtmf-relay = h245-alphanumeric,
        RTP dynamic payload type values: NTE = 101
        Cisco: NSE=100, fax=96, fax-ack=97, dtmf=121, fax-relay=122
               CAS=123, ClearChan=125, PCM switch over u-law=0,A-law=8
               G726r16 using static payload
               G726r24 using static payload
        RTP comfort noise payload type = 19
        fax rate = disable,   payload size =  20 bytes
        fax protocol = system
        fax-relay ecm enable
        fax NSF = 0xAD0051 (default)
        codec = g729r8,   payload size =  20 bytes,
        Media Setting = flow-through (global)
        Expect factor = 10, Icpif = 20,
        Playout Mode is set to adaptive,
        Initial 60 ms, Max 250 ms
        Playout-delay Minimum mode is set to default, value 40 ms
        Fax nominal 300 ms
        Max Redirects = 1, signaling-type = cas,
        VAD = disabled, Poor QOV Trap = disabled,
        Source Interface = NONE
        voice class sip url = system,
        voice class sip rel1xx = system,
        redirect ip2ip = disabled
        probe disabled,
        voice class perm tag = `'
        Time elapsed since last clearing of voice call statistics never
        Connect Time = 1206442855, Charged Units = 0,
        Successful Calls = 116450, Failed Calls = 4153, Incomplete Calls
= 3084
        Accepted Calls = 159, Refused Calls = 862,
        Last Disconnect Cause is "10  ",
        Last Disconnect Text is "normal call clearing (16)",
        Last Setup Time = 628057673.
Matched: 8282438594   Digits: 1
Target: ipv4:192.168.201.6
 
VoiceOverIpPeer1001
        peer type = voice, information type = voice,
        description = `Inbound from PRI to Callmanager1',
        tag = 1001, destination-pattern = `[2-8]...',
        answer-address = `', preference=2,
        CLID Restriction = None
        CLID Network Number = `'
        CLID Second Number sent
        CLID Override RDNIS = disabled,
        source carrier-id = `', target carrier-id = `',
        source trunk-group-label = `',  target trunk-group-label = `',
        numbering Type = `unknown'
        group = 1001, Admin state is up, Operation state is up,
        incoming called-number = `.', connections/maximum = 0/unlimited,
        DTMF Relay = enabled,
        modem transport = passthrough, nse, payload type = 100, codec =
g711ulaw,
,
        URI classes:
            Incoming (Called) =
            Incoming (Calling) =
            Destination =
        huntstop = disabled,
        in bound application associated: 'DEFAULT'
        out bound application associated: ''
        dnis-map =
        permission :both
        incoming COR list:maximum capability
        outgoing COR list:minimum requirement
        Translation profile (Incoming):
        Translation profile (Outgoing):
        incoming call blocking:
        translation-profile = `call_block'
        disconnect-cause = `call-reject'
        advertise 0x40 capacity_update_timer 25 addrFamily 4
oldAddrFamily 4
        type = voip, session-target = `ipv4:192.168.200.2',
        technology prefix:
        settle-call = disabled
        ip media DSCP = ef, ip signaling DSCP = af31,
        ip video rsvp-none DSCP = af41,ip video rsvp-pass DSCP = af41
        ip video rsvp-fail DSCP = af41,
        UDP checksum = disabled,
        session-protocol = cisco, session-transport = system,
        req-qos = best-effort, acc-qos = best-effort,
        req-qos video = best-effort, acc-qos video = best-effort,
        req-qos audio def bandwidth = 64, req-qos audio max bandwidth =
0,
        req-qos video def bandwidth = 384, req-qos video max bandwidth =
0,
        dtmf-relay = h245-alphanumeric,
        RTP dynamic payload type values: NTE = 101
        Cisco: NSE=100, fax=96, fax-ack=97, dtmf=121, fax-relay=122
               CAS=123, ClearChan=125, PCM switch over u-law=0,A-law=8
               G726r16 using static payload
               G726r24 using static payload
        RTP comfort noise payload type = 19
        fax rate = disable,   payload size =  20 bytes
        fax protocol = system
        fax-relay ecm enable
        fax NSF = 0xAD0051 (default)
        codec = g729r8,   payload size =  20 bytes,
        Media Setting = flow-through (global)
        Expect factor = 10, Icpif = 20,
        Playout Mode is set to adaptive,
        Initial 60 ms, Max 250 ms
        Playout-delay Minimum mode is set to default, value 40 ms
        Fax nominal 300 ms
        Max Redirects = 1, signaling-type = cas,
        VAD = disabled, Poor QOV Trap = disabled,
        Source Interface = NONE
        voice class sip url = system,
        voice class sip rel1xx = system,
        redirect ip2ip = disabled
        probe disabled,
        voice class perm tag = `'
        Time elapsed since last clearing of voice call statistics never
        Connect Time = 85227, Charged Units = 0,
        Successful Calls = 18, Failed Calls = 1061, Incomplete Calls = 0
        Accepted Calls = 0, Refused Calls = 0,
        Last Disconnect Cause is "1   ",
        Last Disconnect Text is "unassigned number (1)",
        Last Setup Time = 627628824.
Matched: 8282438594   Digits: 1
Target: ipv4:192.168.200.2
 
CityHall2821#
 
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20120504/91b2c240/attachment.html>
    
    
More information about the cisco-voip
mailing list