[cisco-voip] 7965G delays registering on SCCP v9 firmware

Jason Aarons (AM) jason.aarons at dimensiondata.com
Mon May 14 10:44:39 EDT 2012


I would expect tcp 1500 byte packets alone to cut file transfer time in half vs udp 512 byte in tftp , does peer firmware sharing still use tftp or the new http when this feature goes live?

Sent from my Android phone using TouchDown (www.nitrodesk.com)

-----Original Message-----
From: Wes Sisk [wsisk at cisco.com]
Received: Monday, 14 May 2012, 10:33am
To: Aaron Riemer [ariemer at amnet.net.au]; Jason Aarons (AM) [jason.aarons at us.didata.com]; Ryan Ratliff (rratliff) [rratliff at cisco.com]
CC: Cisco VOIP [cisco-voip at puck.nether.net]
Subject: Re: [cisco-voip] 7965G delays registering on SCCP v9 firmware

3rd gen phones (see: https://supportforums.cisco.com/docs/DOC-8131#Definitions)

*should* get http download in 9.3(1) so long as things go as planned with:
CSCsy15970

this is future planning and therefore subject to change.

Regards,
Wes


On May 14, 2012, at 9:41 AM, Wes Sisk wrote:

10-20 minutes sounds like the time to download the larger loads required by the 79x2 and 79x5 loads. When you reset the phones they re-attempt TFTP. The phones will spin on TFTP transfer for 10-20 minutes, then give up most likely on a failure, and register using the old phone load.

If you check one of the phones that experiences this issue - either in RTMT or in the phone webpage, has it successfully upgraded to the 9.x release or is it still running the 8.x release such that they would attempt upgrade on next reset.

I was not under the impression that 79x2 and 79x5 model phones had http transfer of phone loads yet.  That would be a good point of clarification as to how the phones are attempting upgrade and if any problems occur in that attempt. Usually detailed TFTP traces are adequate.

https://supportforums.cisco.com/docs/DOC-16943

Regards,
Wes

On May 13, 2012, at 2:00 AM, Aaron Riemer wrote:

Hey guys,

We are gradually upgrading our fleet of 7965G's to SCCP v9 software from v8.

We have found an issue at remote sites (higher latency) where phones (with any 9.x firmware) are taking upward of 10-20 minutes to register! This delay seems to only occur when a full power off / power on occurs.

Downgrade the phones back to v8.x and whola! No problem.

We are going to try and simulate this in the lab with a WAN sim and then probably get TAC involved. I suspect it has something to do with the extra latency involved but as mentioned we have had no trouble with v8.x software.

Has anyone come across this problem? It seems a bit oddball I know.

Any hints or suggestions are most welcome.

Thanks,

Aaron.
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net<mailto:cisco-voip at puck.nether.net>
https://puck.nether.net/mailman/listinfo/cisco-voip

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net<mailto:cisco-voip at puck.nether.net>
https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20120514/b7383567/attachment.html>


More information about the cisco-voip mailing list