[cisco-voip] Anyone with Dialogic SR-140 / RightFax experience?

[Scott Voll]

our Rightfax system has a PRI from it to our VGW.  Then we do everything
with CM for Least cost routing.

if your doing H323 can't you do a H323 trunk with CM?

YMMV

Scott

On Fri, May 25, 2012 at 2:17 PM, Jason Aarons (AM) <
jason.aarons at dimensiondata.com> wrote:

> Trying to figure out if I can point RightFax/SR-140 to multiple ip
> addresses based on destination address.****
>
> ** **
>
> I’m pretty sure the RightFax 9.4 / SR-140 doing H323/T38  can only point
> to 1 ip address or RightFax can route to particular SR-140, then it’s up to
> your peer PBX/H323 gateway to do the TEHO/Least Cost Routing etc.****
>
> ** **
>
> ** **
>
> Example customer request, they only have a couple SR-140s and locations in
> many more cities and want outbound to go out the end user’s city.****
>
> ** **
>
> We have some scope items that I want to make sure that we can meet for the
> outbound faxing project.****
>
> ** **
>
> •             Outbound faxes will use the PRI/trunk of the site of the
> originating fax.  For example, if the fax is sent out of Tokyo it will use
> the local Tokyo PRI for the outbound call.****
>
> •             If the outbound trunk is down, the fax can route out of a
> secondary path.****
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20120525/12443c4a/attachment.html>