[cisco-voip] tracing translations easily

[Lelio Fulgenzi]

Thanks James. 

We are using MGCP with CallManager v7. 

We take in all 10 digits from the carrier and use translations to send that to a DN. For example, 519-555-1234 to 56354. Everything works, it's just that there's no clear way to map a call record in CDR to a particular DID. There's a many to one relationship in some cases, especially with wild cards. 

I'd rather not go into traces. Even then, I think I have to enable a parameter for 'complex' diagnostics so each translation is recorded as well. 



--- 
Lelio Fulgenzi, B.A. 
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1 
(519) 824-4120 x56354 (519) 767-1060 FAX (ANNU) 
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
Cooking with unix is easy. You just sed it and forget it. 
- LFJ (with apologies to Mr. Popeil) 


----- Original Message -----
From: "James Avalos" <javalos at adobe.com> 
To: "Lelio Fulgenzi" <lelio at uoguelph.ca>, cisco-voip at puck.nether.net 
Sent: Wednesday, November 21, 2012 12:02:27 PM 
Subject: RE: [cisco-voip] tracing translations easily 




If you’re using H323 as your gateway type, the DID is most likely translated to your DN before it hits call manager, not allowing you to see the dialed digit in CM traces or CDR. 

If you’re using MGCP, you most likely have a translation pattern that will take the digits sent by the carrier and mask them into your DN range. 

Or, your carrier may simply not be sending all 10 digits of your DID. If this is the case, I don’t think you can see the full incoming dialed DID. Some of our offices are configured to just have the last 4 or 5 digits of the DID sent in on the circuit. 

Not sure if this is what you were looking for. I may have completely misunderstood the question… J 



-J 







From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Lelio Fulgenzi 
Sent: Wednesday, November 21, 2012 6:54 AM 
To: cisco-voip at puck.nether.net 
Subject: [cisco-voip] tracing translations easily 




anyone come up with an easy way to trace translations? we get calls to extensions through DIDs, but I only see the extension in the CDR, not the DID. I'd like to know what DID was called (if any). 

lelio 

--- 
Lelio Fulgenzi, B.A. 
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1 
(519) 824-4120 x56354 (519) 767-1060 FAX (ANNU) 
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
Cooking with unix is easy. You just sed it and forget it. 
- LFJ (with apologies to Mr. Popeil) 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20121121/43a6b40d/attachment.html>