[cisco-voip] CUBE call hits CUCM but won't route to PSTN

[Erick Wellnitz]

After more investigation I have found that my trunk was only accepting 4
significant digits even though it was set to accept all digits.


On Tue, Jun 4, 2013 at 12:54 PM, Erick Wellnitz <ewellnitzvoip at gmail.com>wrote:

>
> I have something a little off and need some suggestions.
>
> I have three dial peers being matched for outbound.  One is an exact match
> and gets selected first.  It points to port 5070.
>
> The other two match +1T and point to port 5060.
>
> Called number matches the destination pattern of the first dial peer, does
> it's translation and sends to CM.
>
>
> 364245452| 2013/06/04 10:01:46.979| 002| SdlSig | SIPSetupInd | restart0 |
> SIPD(2,100,65,34) | SIPHandler(2,100,63,1) |
> (2,100,56,1).1780322-(*:10.2xx.17.xxx) | [R:NP - HP: 0, NP: 0, LP: 0, VLP:
> 0, LZP: 0 DBP: 0] SignalInfo= SIPInviteSdp CcbId= 1371534 --TransType=1
> --TransSecurity=0 PeerAddr = 10.2xx.17.xxx:28157 IdParse= 1 callingNum=
> 01144######9317 callingName= UK Caller calledNum= 91######4129
>
> My trunk has the proper CSS configured and the proper port in the security
> profile.  We receive a 404 Not Found but when using DNA it shows the call
> should route. SDL also shows 'no potential matches exist' for 91######4129
> when it starts digit analysis.
>
> The CUBE then tries the remaining two dial peers but because the trunk
> using port 5060 is set to 4 significant digits we get a 404 Not Found.
>
> Any ideas would be greatly appreciated!
>
>
>
> Thanks!
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20130604/e125bf2f/attachment.html>