[cisco-voip] Fax Server Recommendations

[Charles]

Hello Travis,

 

Would you be kind enough to advise on the following issues with Fax
transmission via a SIP ITSP and you're recommendations.

 

I  have an issue with sending fax to via a SipTelco, there are no issue
sending the fax If the Fax is send out via a Pots dialpeer ISDN or Analogue,
however the Primary route is via a  Siptrunk to a Cube voice gateway then
out the SIPTelco (ITSP). The Fax Protocol of Choice is T.38, I have also
tried Fax Pass-Through i.e. not (Fax Passthrough, Cisco). But still no Joy.
It quite clear the issue lies with the inter-connect via the Sip ITSP & the
remote end Efax Server. The FoIP Protocol is set  on the Voip Dial-peers, I
have configured 4, 2 for each ITSP which allows me to carryout test using
either Skype or Sipgate  as the ITSP (T.38 Fax relay or Fax Pass-through)
What is your recommendation.

 

I attached the configuration of the Dial-Peers.

 

Thanks in Advance.

 

dial-peer voice 9912 voip

translation-profile incoming SKYPE-ANI

translation-profile outgoing SKYPE-OUT

preference 1

shutdown

destination-pattern 9.T

media flow-around

no modem passthrough

session protocol sipv2

session target dns:sip.skype.com

session transport udp

incoming called-number 44XXXXXXXX...

voice-class codec 1000  

 no voice-class sip early-offer forced

no voice-class sip pass-thru headers

no voice-class sip pass-thru content unsupp

dtmf-relay rtp-nte

fax rate disable

fax protocol pass-through g711alaw

no vad

!

dial-peer voice 9513 voip

translation-profile incoming SIPGATE-INCOMING

translation-profile outgoing SIPGATE-OUTGOING

preference 1

destination-pattern 9.T

session protocol sipv2

session target dns:sipgate.co.uk

incoming called-number .

voice-class codec 1000  

 voice-class h323 1000

dtmf-relay rtp-nte

fax rate disable

fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback noe

no vad

!

dial-peer voice 9914 voip

translation-profile incoming SIPGATE-INCOMING

translation-profile outgoing SIPGATE-OUTGOING

preference 1

shutdown

destination-pattern 9.T

no modem passthrough

session protocol sipv2

session target dns:sipgate.co.uk

incoming called-number .

voice-class codec 1000  

 voice-class h323 1000

dtmf-relay rtp-nte

fax rate disable

fax protocol pass-through g711alaw

no vad

!

dial-peer voice 9913 voip

translation-profile incoming SIPGATE-INCOMING

translation-profile outgoing SIPGATE-OUTGOING

preference 1

shutdown

destination-pattern 9.T

session protocol sipv2

session target dns:sipgate.co.uk

incoming called-number .

voice-class codec 1000  

 voice-class h323 1000

dtmf-relay rtp-nte

fax rate disable

fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none

no vad

 

Global 

voice service voip

ip address trusted list

address-hiding

media flow-around

allow-connections h323 to h323

allow-connections h323 to sip

allow-connections sip to h323

allow-connections sip to sip

fax protocol t38 version 3 ls-redundancy 0 hs-redundancy 0 fallback none

h323

  h225 timeout setup 3

  h225 display-ie ccm-compatible

  call preserve limit-media-detection

sip

  min-se 7200 session-expires 7200

  sip-profiles 9905

 

 

 

 

.From: cisco-voip [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of
Travis Manson
Sent: 16 November 2013 03:25
To: Scott Voll
Cc: Ken Rhodes; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Fax Server Recommendations

 

I work on right fax for a living, let me know if you have any questions and
i will do my best to answer them.

 

On Fri, Nov 15, 2013 at 12:40 PM, Scott Voll <svoll.voip at gmail.com> wrote:

used Xmedius at my previous job and have Right fax at my current job.  Both
do the job, but If I had the option..... I would definitely go with Xmedius.

 

Scott

 

On Thu, Nov 14, 2013 at 12:21 PM, Ken Rhodes <kenneth.rhodes at gmail.com>
wrote:

Does anyone have recommendations about a good fax server solution that can
be implement using SIP trunks? Or are there any that we should stay away
from based off personal experience?

We are in the beginning stages of exploring a fax solution and I was just
looking for any suggestions.

FYI: We are running CUCM (8.6.2a) and currently we are using VG's for our
faxes today.

Thanks
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

 


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20131116/dd2e735d/attachment.html>