[cisco-voip] Fax Server Recommendations

Travis Manson tmanson01 at gmail.com
Sat Nov 16 06:35:16 EST 2013


Hey Charles,

your config for the cubes looks fine, as i can see both t.38 and g711 pass
through enabled on 9913 and 9914 respectively.

can you do me a favor, and send me a wireshark trace of a failed call? just
run the trace on the rightfax server


On Sat, Nov 16, 2013 at 4:14 AM, Charles <charles at moore1.net> wrote:

> Hello Travis,
>
>
>
> Would you be kind enough to advise on the following issues with Fax
> transmission via a SIP ITSP and you’re recommendations.
>
>
>
> I  have an issue with sending fax to via a SipTelco, there are no issue
> sending the fax If the Fax is send out via a Pots dialpeer ISDN or
> Analogue, however the Primary route is via a  Siptrunk to a Cube voice
> gateway then out the SIPTelco (ITSP). The Fax Protocol of Choice is T.38, I
> have also tried Fax Pass-Through i.e. not (Fax Passthrough, Cisco). But
> still no Joy. It quite clear the issue lies with the inter-connect via the
> Sip ITSP & the remote end Efax Server. The FoIP Protocol is set  on the
> Voip Dial-peers, I have configured 4, 2 for each ITSP which allows me to
> carryout test using either Skype or Sipgate  as the ITSP (T.38 Fax relay or
> Fax Pass-through) What is your recommendation.
>
>
>
> *I attached the configuration of the Dial-Peers.*
>
>
>
> *Thanks in Advance.*
>
>
>
> *dial-peer voice 9912 voip*
>
> translation-profile incoming SKYPE-ANI
>
> translation-profile outgoing SKYPE-OUT
>
> preference 1
>
> shutdown
>
> destination-pattern 9.T
>
> media flow-around
>
> no modem passthrough
>
> session protocol sipv2
>
> session target dns:sip.skype.com
>
> session transport udp
>
> incoming called-number 44XXXXXXXX...
>
> voice-class codec 1000
>
>  no voice-class sip early-offer forced
>
> no voice-class sip pass-thru headers
>
> no voice-class sip pass-thru content unsupp
>
> dtmf-relay rtp-nte
>
> fax rate disable
>
> fax protocol pass-through g711alaw
>
> no vad
>
> !
>
> *dial-peer voice 9513 voip*
>
> translation-profile incoming SIPGATE-INCOMING
>
> translation-profile outgoing SIPGATE-OUTGOING
>
> preference 1
>
> destination-pattern 9.T
>
> session protocol sipv2
>
> session target dns:sipgate.co.uk
>
> incoming called-number .
>
> voice-class codec 1000
>
>  voice-class h323 1000
>
> dtmf-relay rtp-nte
>
> fax rate disable
>
> fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback noe
>
> no vad
>
> !
>
> *dial-peer voice 9914 voip*
>
> translation-profile incoming SIPGATE-INCOMING
>
> translation-profile outgoing SIPGATE-OUTGOING
>
> preference 1
>
> shutdown
>
> destination-pattern 9.T
>
> no modem passthrough
>
> session protocol sipv2
>
> session target dns:sipgate.co.uk
>
> incoming called-number .
>
> voice-class codec 1000
>
>  voice-class h323 1000
>
> dtmf-relay rtp-nte
>
> fax rate disable
>
> fax protocol pass-through g711alaw
>
> no vad
>
> !
>
> *dial-peer voice 9913 voip*
>
> translation-profile incoming SIPGATE-INCOMING
>
> translation-profile outgoing SIPGATE-OUTGOING
>
> preference 1
>
> shutdown
>
> destination-pattern 9.T
>
> session protocol sipv2
>
> session target dns:sipgate.co.uk
>
> incoming called-number .
>
> voice-class codec 1000
>
>  voice-class h323 1000
>
> dtmf-relay rtp-nte
>
> fax rate disable
>
> fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none
>
> no vad
>
>
>
> Global
>
> voice service voip
>
> ip address trusted list
>
> address-hiding
>
> media flow-around
>
> allow-connections h323 to h323
>
> allow-connections h323 to sip
>
> allow-connections sip to h323
>
> allow-connections sip to sip
>
> fax protocol t38 version 3 ls-redundancy 0 hs-redundancy 0 fallback none
>
> h323
>
>   h225 timeout setup 3
>
>   h225 display-ie ccm-compatible
>
>   call preserve limit-media-detection
>
> sip
>
>   min-se 7200 session-expires 7200
>
>   sip-profiles 9905
>
>
>
>
>
>
>
>
>
> *.From:* cisco-voip [mailto:cisco-voip-bounces at puck.nether.net] *On
> Behalf Of *Travis Manson
> *Sent:* 16 November 2013 03:25
> *To:* Scott Voll
> *Cc:* Ken Rhodes; cisco-voip at puck.nether.net
>
> *Subject:* Re: [cisco-voip] Fax Server Recommendations
>
>
>
> I work on right fax for a living, let me know if you have any questions
> and i will do my best to answer them.
>
>
>
> On Fri, Nov 15, 2013 at 12:40 PM, Scott Voll <svoll.voip at gmail.com> wrote:
>
> used Xmedius at my previous job and have Right fax at my current job.
>  Both do the job, but If I had the option..... I would definitely go with
> Xmedius.
>
>
>
> Scott
>
>
>
> On Thu, Nov 14, 2013 at 12:21 PM, Ken Rhodes <kenneth.rhodes at gmail.com>
> wrote:
>
> Does anyone have recommendations about a good fax server solution that can
> be implement using SIP trunks? Or are there any that we should stay away
> from based off personal experience?
>
> We are in the beginning stages of exploring a fax solution and I was just
> looking for any suggestions.
>
> FYI: We are running CUCM (8.6.2a) and currently we are using VG's for our
> faxes today.
>
> Thanks
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20131116/0f5cec79/attachment.html>


More information about the cisco-voip mailing list