[cisco-voip] NFAS t1

[Charles Goldsmith]

No, it's not, we cleared the pri-group's on both controllers by shutting
down both voice-port and serial interfaces, removed the pri-group's, then
added in correct config for NFAS.

Going to open a TAC case in a bit on it.

On Mon, Dec 1, 2014 at 3:46 PM, Brian Meade <bmeade90 at vt.edu> wrote:

> Is the pri-group already configured on that controller?  If so, you'll
> need to shut down the voice-port, the serial interface, and then do "no
> pri-group" on the controller before re-defining the pri-group configuration.
>
> On Mon, Dec 1, 2014 at 5:37 PM, Charles Goldsmith <wokka at justfamily.org>
> wrote:
>
>> We are seeing an odd error on a migration from a Nortel setup over to an
>> h323 setup.
>>
>> the error message after entering PRI 2 is
>>
>> *crsvr1(config-controller)#pri-group timeslots 1-24 nfas_ backup nfas_int
>> 1 nfas_group 1*
>>
>> *%The Primary-group is already defined*
>> *%The first definition of the primary-group must be removed before the
>> primary-group can be redefined*
>>
>> Getting this after putting the timeslots command on the first pri, then
>> seeing this error on the 2nd controller.
>>
>> This is on 15.2 on a 3945.  I've done this before with no issues, but
>> have never seen this error before.
>>
>> Thanks
>>
>>
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20141201/d2a4633f/attachment.html>