[cisco-voip] CISCO VOIP/PSTN STE

[george.hendrix at l-3com.com]

Hi Henry,

  Have you resolved this?  I have also seen issues with STE's going secure as well, whether it be direct on the router as you have below, or any other setup, even though all devices are setup and calls go thru just fine.

-Bill

-----Original Message-----
From: cisco-voip [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of AKIN, HENRY D JR CTR USAF AFGSC AFGSC/A7XN
Sent: Thursday, July 10, 2014 5:27 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] CISCO VOIP/PSTN STE

I am having problems configuring a CISCO 3825-CCME/K9  with 2 VIC-4FXS/DID cards and a 16 port POE switch NM-16ESW-PWR

IOS 12.4


We are configured with SCCP, H.323

I can make voice calls on all phones PSTN and VOIP however, when I attempt to transition to a secure call using a STE on a PSTN port the call drops after ~ 30 Sec.  Any suggestions would be appreciated.

aaa new-model
!
aaa authentication login default local
aaa authorization exec default local common

voice-card 0
 dspfarm
 dsp services dspfarm

voice service voip
 fax protocol cisco
 modem passthrough nse codec g711ulaw
 modem relay latency 100
 modem relay sprt v14 receive playback hold-time 35

interface Loopback1
 description CME_Address
 ip address xxx.xxx.xxx.xxx 255.255.255.255  h323-gateway voip interface  h323-gateway voip bind srcaddr xxx.xxx.xxx.xxx

sccp local Loopback1
sccp ccm xxx.xxx.xxx.xxx identifier 1 version 3.1 sccp !
sccp ccm group 1
 bind interface Loopback associate profile 1 register CME_DSP

dspfarm profile 1 transcode
 codec g729abr8
 codec g729ar8
 codec g711alaw
 codec g711ulaw
 codec g729r8
 maximum sessions 7
 associate application SCCP

control-plane
voice-port 0/0/0
voice-port 0/0/1
 no battery-reversal
voice-port 0/0/2
voice-port 0/0/3
voice-port 0/1/0
voice-port 0/1/1
voice-port 0/1/2
voice-port 0/1/3


ip access-list extended VOIP-TCP
permit tcp host XXX.XXX.XXX.67 any
permit tcp any host XXX.XXX.XXX.67
permit tcp host 100.1.1.1 any
permit tcp any host 100.1.1.1
!
ip access-list extended VOIP-UDP
permit udp host XXX.XXX.XXX.67 any
permit udp any host XXX.XXX.XXX.67
permit udp host 100.1.1.1 any
permit udp any host 100.1.1.1

dial-peer voice 5139 pots
 description STE PSTN
 destination-pattern XXXXXX5139$
 incoming called-number XXXXXX5139
 port 0/0/0



_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip