[cisco-voip] Installing CUPS 9 Subscriber - fails on connectivity

Brian Meade bmeade90 at vt.edu
Wed Jun 25 15:07:17 EDT 2014


You can run a packet capture on the publisher while it does the
connectivity test:
utils network capture eth0 size all count 100000 file cupsconntest

Then grab the file via:
file get activelog platform/cli/cupsconntest.cap

But you may need to run a capture on the sub side as well in case some
traffic isn't making it to the pub.


On Wed, Jun 25, 2014 at 1:54 PM, Jeffrey Girard <
jeffrey.girard at girardinc.com> wrote:

> Fails at the same location with the same error when using DNS as well…
>
>
>
> Jeff
>
>
>
> *From:* cisco-voip [mailto:cisco-voip-bounces at puck.nether.net] *On Behalf
> Of *Jeffrey Girard
> *Sent:* Wednesday, June 25, 2014 12:45 PM
> *To:* MManly at TEP.com; cisco-voip at puck.nether.net
> *Subject:* Re: [cisco-voip] Installing CUPS 9 Subscriber - fails on
> connectivity
>
>
>
> I was only using IP addressing.
>
>
>
> However, I just stood up a MS DNS server and am re-running the install
> using that and I configured the CUPS Sub install to be a DNS client to see
> if that makes any difference….
>
>
>
>
> ------------------------------------------------------------------------------------
>
> Dr. Jeffrey T. Girard (Jeff), PhD
>
> Colonel, United States Army (Retired)
>
> Senior Network Engineer / VoIP Engineer - WireMeHappy.com
>
> reply to: jeffrey.girard at wiremehappy.com
>
> (607)835-0406 (home office)
>
> (845)764-1661 (mobile)
>
> (607)835-0458 (fax)
>
>
>
> *From:* MManly at TEP.com [mailto:MManly at TEP.com <MManly at TEP.com>]
> *Sent:* Wednesday, June 25, 2014 12:42 PM
> *To:* Jeffrey Girard; cisco-voip at puck.nether.net
> *Subject:* RE: Installing CUPS 9 Subscriber - fails on connectivity
>
>
>
> Did you enable DNS on either of the servers upon install or are you
> strictly using IP addressing?
>
>
>
> *From:* cisco-voip [mailto:cisco-voip-bounces at puck.nether.net
> <cisco-voip-bounces at puck.nether.net>] *On Behalf Of *Jeffrey Girard
> *Sent:* Wednesday, June 25, 2014 9:34 AM
> *To:* cisco-voip (cisco-voip at puck.nether.net)
> *Subject:* [cisco-voip] Installing CUPS 9 Subscriber - fails on
> connectivity
>
>
>
> Trying to install a CUPS subscriber in a lab environment.  Version 9
>
>
>
> CUPS publisher installed fine.
>
>
>
> I started all the services on the Publisher and ran through the initial
> install wizard
>
>
>
> I added the subscriber to the Publisher under System -> Cluster Topology
> -> DefaultCUPSubcluster
>
>
>
> When I install the CUPS sub, it fails when checking connectivity to the
> Pub.
>
>
>
> The error window says “Connectivity check to CUPSPub (172.16.57.59) failed
>
> Is the network connection for CUPSSub up?
>
> Is the network connection for CUPSPub up?
>
> Is CUPSPub powered on?
>
>
>
> These VMs are on different subnets.  From a third subnet, I was able to
> ping both CUPS VMs.  From the CUPSPub CLI, I was able to use utils network
> ping 172.16.41.251 (IP Address of the CUPSSub) and it was successful.
>
>
>
> Any ideas?
>
>
>
> Jeff
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20140625/3e4a9cb3/attachment.html>


More information about the cisco-voip mailing list