[cisco-voip] NFAS Outbound Selection Order

[steve.siltman at assurant.com]

Hi All,

NFAS Outbound call interface selection order always seemed clear to me 
until today.  For example, I have 5 T1's configured in a single NFAS 
group.  Interface 0 thru 4.  Incoming calls use the b channels on 
Interface 0 and work its way towards interface 4.  Outbound calls use 
Interface 4 and work its was towards Interface 0.   I've started running 
into a glare issue at one of my locations and noticed that the outbound 
calls in the above scenario are using Interface 3 first then Interface 1 
next which starts stepping on the incoming calls.  Does outbound selection 
order look at physical slot placement of the circuit rather than the 
Interface # configured on NFAS?

Thanks,

Steve 
steve.siltman at assurant.com

**********************************************************************
This e-mail message and all attachments transmitted with it may contain legally privileged and/or confidential information intended solely for the use of the addressee(s). If the reader of this message is not the intended recipient, you are hereby notified that any reading, dissemination, distribution, copying, forwarding or other use of this message or its attachments is strictly prohibited. If you have received this message in error, please notify the sender immediately and delete this message and all copies and backups thereof. Thank you.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20140506/c2accbef/attachment.html>