[cisco-voip] vSwitch in Active/Standby

[Matthew Collins]

Hi Jason,

In active standby mode both ports should be up/up on the switch.

Regards

Matthew

ǀ BLOCK ǀ
Cisco UK&I Solution Innovation Partner of the Year FY15

From: cisco-voip [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jason Aarons (AM)
Sent: 19 September 2014 19:26
To: cisco-voip (cisco-voip at puck.nether.net)
Subject: [cisco-voip] vSwitch in Active/Standby

I can’t recall and don’t have access to this right now to ESXi 5 to check.

If I configure in ESXi a vSwitch2 as Active/Standby, then the second NIC in Standby on the 3750 Switchport would show down/down right?  Or will it show up/up and ESXi will “activate” it as needed.

Discussing if the Standby 3750 Switchport has to go Up and run thru Spanning Tree (if portfast is not configured) during Active/Standby failover.


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20140920/7d04c7a6/attachment.html>