[cisco-voip] Rightfax transmission errors

[Carlo Calabrese]

Can you send a part of the configs on the 3925, 
include the 
voice service voip
voice class codec
dial-peers

I connect to 3 rightfax servers with no problems.  The one problem we did run into on each one of them was the servers firewall settings. Try turning that off and see if it connects.


Here is what I have on my 3945s.


voice service voip
 ip address trusted list
  ipv4 172.xx.xx.146
  ipv4 172.xx.xx.162
  ipv4 172.xx.xx.54
  ipv4 172.xx.xx.9
  ipv4 172.xx.xx.100
  ipv4 172.xx.xx.50
  ipv4 172.xx.xx.82
  ipv4 172.xx.xx.5
  ipv4 172.xx.xx.20
 allow-connections h323 to sip
 allow-connections sip to h323
 allow-connections sip to sip
 fax protocol t38 version 0 ls-redundancy 3 hs-redundancy 2 fallback none
 h323
  h225 timeout setup 5
 modem passthrough nse codec g711ulaw
 sip
  bind control source-interface Loopback0
  bind media source-interface Loopback0
  early-offer forced
!
voice class codec 1
 codec preference 1 g711ulaw
 codec preference 2 g729r8
!



dial-peer voice 112 voip
 corlist incoming TOPSTN
 corlist outgoing TODVS
 tone ringback alert-no-PI
 description Inbound 10-digit VOIP peer
 preference 1
 destination-pattern .T
 progress_ind setup enable 3
 progress_ind progress enable 8
 progress_ind connect enable 8
 session protocol sipv2
 session target ipv4:172.XX.xx.50
 incoming called-number .T
 voice-class codec 1
 dtmf-relay rtp-nte
 fax rate 14400
!