[cisco-voip] ATA190 Plar SIP Dial Rule

[Barry Howser]

hi Brian,

So what you're saying is that in the SIP dial rule; I'll click the "Add
Plar" button and then give my parameter a description, select "Button" as
my dial parameter then in the value box I'd enter a "1" or a "2" depending
on if I wanted the *PLAR* working on line 1 or 2 of the ATA.

I would then assume that if I wanted both ATA lines to plar, I would have
two parameters in the SIP dial rule?

Oyyyy ..... I wish you would write Cisco docs .... I can understand you,
lol.


On Fri, Mar 13, 2015 at 3:38 PM, Brian Meade <bmeade90 at vt.edu> wrote:

> For the SIP Dial Rule, all you want it to have is a PLAR with Button 1
> set.  Don't enter the number you want to PLAR to.  Then just set up PLAR
> like you would for a SCCP phone with a new CSS/partition/blank translation
> pattern.
>
> On Fri, Mar 13, 2015 at 3:30 PM, Barry Howser <bhowser5050 at gmail.com>
> wrote:
>
>> Hello everyone.
>>
>> I have an ATA190 that needs to do a plar to 911. My dial plan uses "9" to
>> access an outside line (including the 911 pattern).
>>
>> I created a SIP dial rule and added a plar pattern. I added a parameter
>> called "911" in the description and then added 9911 in the value field. I
>> saved, applied config and restarted.
>>
>> I have applied that SIP Dial Rule to the ATA190 device's sip dial rule
>> section and reset the ATA. When I take either of the lines off hook with an
>> analog phone, I just get dial tone .... no PLARing.
>>
>> What am I doing wrong?
>>
>> thanks
>>
>> _______________________________________________
>> cisco-voip mailing list
>> cisco-voip at puck.nether.net
>> https://puck.nether.net/mailman/listinfo/cisco-voip
>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20150313/03cea4f0/attachment.html>