[cisco-voip] UCME to CUCM integration

[Brian Meade]

Henry,

So the call does ring on the CUCM phone then?  Do you get audio after
answering before it hangs up after 10 seconds?

Try running "debug h225 asn1" and "debug h225 q931" to see why the call is
disconnected.

If you never get audio, it could be a codec issue.  What codec or
voice-class codec do you have assigned to the outbound dial-peers?

Brian

On Thu, Oct 22, 2015 at 2:27 PM, Henry Gicheru (KE) <
henry.gicheru at dimensiondata.com> wrote:

>
>
> Hi Guys,
>
>
>
> Please assist here.
>
> Have this setup; Added the CUCME router as a H323 Gateway on the CUCM and
> created a route pattern pointing to that gateway. On CUCME, I have added
> some dial peers pointing to the CUCM nodes. The CUCME router has IOS
> 15.4(3) and the IP Phones are 7821.
>
> Calls from CUCM to CUCME completely successfully and communication is
> happening. Calls from CUCME to CUCM to both SCCP and SIP IP phones
> disconnect with 10 seconds of being answered.
>
> Have also tried using SIP trunk but the results are the same.
>
>
>
>
>
> Regards,
>
> *Henry Gicheru *System Engineer
> Dimension Data
> Tel: +25420 499 3000
> Mobile: +254733477307
>
> Fax:+254204993200
>
> henry.gicheru at dimensiondata.com
>
>
>
>
>
>
> This email and all contents are subject to the following disclaimer:
> "http://www.dimensiondata.com/emaildisclaimer"
> <http://www.dimensiondata.com/Global/Policies/Pages/Email-Disclaimer.aspx>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20151022/5dec1447/attachment.html>