[cisco-voip] Integrate ROLM 9751 to Cisco ISR 4331

Sam Jones jonesamu at isu.edu
Wed Dec 14 17:06:55 EST 2016


Hi all,

I am working on trying to migrate some legacy ROLM PRI connections from
Cisco 3825 to Cisco ISR 4331.  I am trying to figure out the correct
configuration on the ISR.  The current configuration on the 3825 looks like
this:

Config 3825:
-----------------------
voice-card 1
!
controller T1 1/0
 clock source internal
 pri-group timeslots 1-24 service mgcp
!
interface Serial1/0:23
 no ip address
 encapsulation hdlc
 no logging event link-status
 isdn switch-type primary-dms100
 isdn protocol-emulate network
 isdn incoming-voice voice
 isdn bind-l3 ccm-manager
 no cdp enable
!
-----------------------

This is what I have on the ISR 4331 and some of the PRIs ran clean and
others had frame slips on the ROLM side.

Config 4331:
-----------------------
voice-card 0/1
 no watchdog
!
controller T1 0/1/0
 framing esf
 linecode b8zs
 cablelength long 0db
 pri-group timeslots 1-24 service mgcp
!
interface Serial0/1/0:23
 encapsulation hdlc
 isdn switch-type primary-dms100
 isdn protocol-emulate network
 isdn incoming-voice voice
 isdn bind-l3 ccm-manager
 no cdp enable
!
-----------------------


*Sam Jones*
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20161214/ba48a98f/attachment.html>


More information about the cisco-voip mailing list