[cisco-voip] no ringback tone for incoming calls

[Brian Meade]

Is this for initial ringback or ringback while a call is being transferred
after selecting an option?  CUCM uses annunciators for playing ringback on
a transfer scenario so you might want to check the gateway MRGL has access
to annunciator resources.

On Wed, May 3, 2017 at 10:00 PM, naresh rathore <nareh84 at hotmail.com> wrote:

> hi,
>
>
>
> I am facing the issue in which when i call internal trigger number (CUCM
> ---> UCCX), i can hear the ringback tone. but when i call from mobile to
> the voicegateway (mobile -------ISDN-----> voice gateway ------H323
> --------------> CUCM) i cant hear ringback tone when i select the option in
> IVR.
>
>
> progress indicator setup 3 is already configured. see the following
> dialpeer on the voice gateway
>
>
> rap-adl-rc01#sh run | sec dial-peer
> dial-peer voice 2001 voip
>  description Publisher
>  translation-profile incoming Outside-Lines-Inbound
>  preference 2
>  destination-pattern 888..
>  progress_ind setup enable 3
>  session target ipv4:<cucm pub>
>  incoming called-number .
>  voice-class codec 10
>  voice-class h323 10
>  dtmf-relay cisco-rtp h245-signal h245-alphanumeric
>  no vad
> dial-peer voice 2002 voip
>  description Subscriber
>  translation-profile outgoing Outside-Lines-Outbound
>  preference 1
>  destination-pattern 888..
>  progress_ind setup enable 3
>  session target ipv4:<cucm-sub>
>  incoming called-number .
>  voice-class codec 10
>  voice-class h323 10
>  dtmf-relay cisco-rtp h245-signal h245-alphanumeric
>
>
> Regards
>
>
> Naresh Rathore
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20170504/151ea8c2/attachment.html>