[cisco-voip] Single button ARD

[Matthew Huff]

I'm trying to setup a button on people's phone where they will get inbound calls like a (DN) when voice-port goes off-hook on our gateway (connection plar xxxx). When the button is pressed on any phone, it should do the same thing, take the channel off hook on the voice gateway.

All the example's I've seen are for doing PLAR when the phone goes offhook or the "new call button" is pressed, but not a separate line.

I've done this in the past with CME like:


voice-port 0/3/1:0
define Tx-bits idle 1111
define Tx-bits seize 0000
define Rx-bits idle 1111
define Rx-bits seize 0000
no vad
no comfort-noise
connection plar B100

ephone-dn  32
number B100
trunk B101

Matthew Huff | Director of Technical Operations | OTA Management LLC

Office: 914-460-4039
mhuff at ox.com<mailto:mhuff at ox.com> | www.ox.com<http://www.ox.com>
...........................................................................................................................................

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://puck.nether.net/pipermail/cisco-voip/attachments/20211008/b03d075c/attachment.htm>